5
1 041

Printing the Attack on Titans emblem

Robo 3d R1 Plus. Using filament from Solutech 3d. Using .200 mm layer height with an infill of 20%.
Printing them out in white so they can be hand painted. I'll be dropping some pictures on our instagram of the painted versions so stop by there and check it out!

มุมมอง: 67

วีดีโอ

4:49

My Simplify 3d settings part 2

มุมมอง 4097 ปีที่แล้ว

In this episode I go through the rest of the process settings I have setup for my Robo 3d R1 plus. m. dragonfireprinting #3dprinting #dragonfireprinting #amazing #awesome #cool #kool #changetheworld #demondabber #robo3d #simplify3d #colorado #coloradosprings #learning #createtheworld

4:51

My Simplify 3d settings part 1

มุมมอง 3997 ปีที่แล้ว

In this episode I begin to go over the first few tabs of my processes in the program simplify 3d. In these episodes I do not go over what the settings are but rather what I have my current levels set at. I will be going more in-depth on the settings themselves in a later episode. Hope you all enjoy and find this helpful. m. dragonfireprinting #3dprinting #dragonfireprinting #amazing...

10:00

3d printed soldier bust!

มุมมอง 287 ปีที่แล้ว

This is a 3d bust of PFC Floyd Lindstrom. This was printed on a Robo 3d R1 plus. Simplify 3d was used to print this. Please follow the link below to find out more about him: en.m.wikipedia.org/wiki/Floyd_K._Lindstrom #3dprinting #dragonfireprinting #awesome #printer #changingtheworld #changingthefuture #filament #colorfabb

ความคิดเห็น

@MrPhantom302 7 ปีที่แล้ว
Hi sir I have a ? I follow your directions but when I hit ok it say " each extruder should have a unique temperature identifier number " but i only have one extruder on my robo r1 so what did I miss . Thanks

Dragon Fire Printing and Goods

ความคิดเห็น