วีดีโอ

yesssssssssssssssssss usa!

Solution, super glue it in place. Leave on helmet. I just bought these & found they removed the FM radio, wasted my money too !!

I see that this clamp kit is now sold by Sena as for the Mag 9 only not the Qualifier. Same part number as when it was sold as suitable for both helmets though.....!

just bought the Sena10s for my Bell Qualifier... It does not fit, and all. Called and they, no it doesn't you have to buy and different bracket.. $62!! So for $220 i just bought the camera... and the rest is useless... This doesn't make any sense to me !! Why would it fit directly in the helmet but not work with the clamp they send you... Am I seeing something wrong?

The mount is very finicky but you can get it work very well is you modify the helmet a tiny bit. I trimmed a bit of the foam where the mic comes into the mount so it wasn't putting any stress on the mount. Additionally i trimmed the plastic on the cheek pad that slides behind the mount and lastly i left the screw a little loose. Basically if you try to put the sena on the mount outside the helmet it snaps in perfectly meaning the helmet stresses/deforms the mount geometry a little bit. You kinda need to try and remove as many of the contact/pressure points between the mount and helmet as possible.

Here's the problem with this video. The Bell Qualifier DLX helmet with the cut out for a blue tooth comm system is made to accommodate the Bell Mag-9 Qualifier DLX Sena SMH-10 Bluetooth headset (which is specifically made for the Bell Qualifier DLX helmet), NOT the Sena 10S. So this guy who made this video bought the wrong headset for his Bell helmet, that's why it pops out. There's absolutely nothing wrong with Sena's clamp mount. I've been using it on my helmet for a few years and thousands of miles with no issues at all.

there are two skus offered by Sena- one with each number 10s and smh10- I tried both and neither worked. perhaps the age of the 10s has something to do with the issue.

Same here. Not happy.

c est pas dure a comprendre….. c est fait pour le vieux modèle SMH10 … SEULEMENT

Works great with my SMH10. No problems.

Had the same issue with the 10S. It goes in ok when clamp is off the helmet. My only guess is the way the plastic locking wedge on the 10S is compared to the SMH-10 is much smaller and softer angles. I contacted Revzilla, they shipped out a new clamp, contacted Bell and they shipped out a new helmet. Contacted Sena and they were unwilling to send out a replacement until I sent in mine, and said that they didn't have any, so I would be out a unit for potentially months. Kept getting the same lady via phone and email. She's a stonewaller, and tries to backslide out of warranty exchanges. Only thing that saved me was I contacted them about it the second day I had it. After going through all the other avenues they told me to go down she tried to say I was out of warranty period for exchanges. I told her I contacted her first and showed copies of the emails I sent her, and she finally relented and said that yes, I had contacted them. Worst customer service I've ever dealt with

Nearly certain it's meant for smh10, not 10s.

same happens to me all the time every time put on helmet ,i have a fix black zip ty 1inch long folded in half pushed in clip to hold in place seems to work very expensive piece to loose not impressed with this engineering .helmet flex causes this .not satisfied customer.

Any chance you found a solution for this? I've had the same issue and tried shaving down some of the material to get it to fit more snugly. Both my helmet and clip look so mangled now, there's no way I could return them...

how cute, suitable for a 3year old

First

Very cool! Who knew I would find this when Googling "geolemon" because someone's BetterAudio page is down...?