This is the current status of my long running project as of December 2024. It is intended to modernize classic instrument clusters while keeping the classic aesthetic. I saw too many vintage cars with an iPad slapped on the dash, and knew there was a hole in the market. To be clear, this is still going to require a lot of ingenuity from the end user to figure out how to mount the components in their own specific application, but should not require any programming knowledge.
Inputs
CAN Bus (currently using Haltech protocol, but can use Megasquirt, AiM, OBDII, etc)
GPS
3x General Analog Inputs
1x Fuel Level
1x Thermistor
1x Speed input
1x Coil Negative (RPM from coil)
Rotary Encoder
Outputs
4x Gauge Stepper Motors
2x OLED screens (128x32 pixels)
LED Tachometer
Odometer Stepper Motor
2x Low Side Outputs (warning light or relay control)