วีดีโอ

🔥

??????????????????????????????????????????? DOC , FEED , SPEED ?????????????????????????? WTF are u doing????? b Its Brass !!!!!!!!!!!!!!!!!!!!!!!

AAAAWWWWW! Did you checked the clamping of the workpiece before starting? It looked very wiggely.😁

Kralım g71 çevrimi kullanmışsın dogrumudur?

You are do it like a deletant! No idea how you get certified.

Hello,no sense if you realize centering before turning on the top and arrive over it in header.This generate a tracing drool so you need to restore at the end. You not use it so the things not needed it's only lost time do that.I suppose you do that for replace a misalignment of the outside tools.... Another observation:you use shorter clamps and a smallest diameter than total lenght of the parts.When I look on that have idea you turn outside diameter too but was not.In this way you can use longer clamps and over outside diameter. You will have safety job and can push more and more over cutting parameters with more precision too.

kardeş bak eyvallah böyle videolar atıyorsun ama seni gören gençler örnek alırsa ortalık fena karışır susuz tezgahmı yollanır Allah aşkına

Put the tailstock on and you can run so much faster. I always use it

Yanıyorsun fuat abi😂

Да так мусолить можно неделю!!! Бе

А нахуя ее центровали? Или я чета не понял?

Usta,m döktürmüs masAllah.

Why you dont use a tailstock? Then you can easily increase cutting parameter 😊

bro forgot to put wingdings in the hashtags

Looks a bit slow on the DOC and feeds. Watch your machine's power monitor to see if you can improve the roughing operation. I run parts like this at 2,5 - 4 mm DOC and around 0.5 mm/ rev using a W insert with 0.8 or 1.2 mm nose radius. Especially increasing the feed rate is always a good idea - it improves chip breaking practically always.

Kardeş bana numaranı atabilirmisin.

hi how are you let machine operator I am let mission operator

VİDEO ÇEKECEM DİYE PARÇANIN YÜZEYİ BOZUK ÇIKTI SUSUZ ÇALIŞTIRDIGIN İÇİN MASTER

Elmas yandı gardaş;)