- 2
- 21 648
Joe Ducharme
เข้าร่วมเมื่อ 26 ก.พ. 2015
1996 Yamaha Wave Venture - Turns Over But Does Not Run (kill switch)
This is a pretty common problem with these skies. The kill switch just goes bad.
If the ski still does not start after unplugging the wire then check for spark. There my be a bigger electrical issue.
If the ski still does not start after unplugging the wire then check for spark. There my be a bigger electrical issue.
มุมมอง: 15 992
วีดีโอ
Fuse Replacement - 1996 Yamaha Wave Venture 1100
มุมมอง 6K3 ปีที่แล้ว
This video should apply to many other Yamaha 2-stroke jets skies of this era.
thanks for sharing!
I got the exact same wave runner but mine will crank for 2 seconds then completely stop
Yeah my jet ski turns over but wont start it just died while i was out on the water i figured it was the fuel pump but i got a new one but it acts like its not even turning on
I have a 1995 700 started at the dock . Got on yo start again after turning it off . Doesn’t want to turn over . Any suggestions ( I’m charging the battery as I write this comment .)
Any idea where the fuse is on a 1995 wave runner 700 ?
Thanks for the video!! Such a small little piece, can bring the whole system down. Lol
mine starts and runs fine but i cant shut it off wont start with lanyard off but lanyard on it runs and starts as normal...pulling the lanyard doesnt stop it, the stop button doesnt stop it either. i watched another video where this was the problem and they replaced CDI to resolve issue. any help appreciated...
Well because your lanyard switch allows it to not start, I wouldn’t say the buttons are bad. It’s most likely an electrical issue further up the line. There’s a 2-pronged plug coming from the controls. Take it apart and it shouldn’t be able to stop but if you jump the two prongs together it should stop. I show where the plug is in my other video.
What were the symptoms that caused you to replace yhw fuse
I washed the inside of my jetski bay and now I'm not getting nothing when I put the key in, it's not turning over or anything. I'll try those wires
Lol. That’s exactly what happened with mine. I washed the inside, then the fuse blew
Thanks!!! How do you if you need a fuse? Just curious because my display is partially working and was wondering if that’s the issue.
Did you figure out if replacing the fuse did the trick on partially working display?
Nice! thanks for the info. I rebuilt one of these engines. See my channel if you are interested.
Nice tips. thank you.
mine is doing the same. my kill switch is good
Thaaank you
I was out on the water and and it died and when I got back to shore yeah sure and clean the plugs it started. I clean the plugs and whand one pack out ran good for about 15 minutes then stalled I heard that you get 25 hours or 4 or 5 good trips on it before you should change the plugs
That is definitely a problem with these skies. It mostly effects mine at idle. I also find that if I don’t run it for a week or two on the water the plugs go bad.
It's says 2 ch a new after 20 hrs or 4 to5 rides
I change purges and ran good 4 11/2 hrthan shut off.again
Hey do you know how to do the twin carb on this or how to take it apart and clean it? Just bought one of these yesterday it turns over but bogs from time to time and have to play with the choke to get it to start.
Buy a carb rebuild kit for the ski. I got mine from jc racing
Just bought this same ski yesterday bought a new battery an nothing... I'ma try this thanks alot for the video I seen it say fuse on top of rubber but couldn't find it shop wants $80 to swap fuse 🤯
Any luck?
$80? That’s cheap.