วีดีโอ

Can you tell me the best catalytic converter for my 2009 Honda Accord IV tech engine, ,so can you send me the link so that I can buy from there? I need the cheap and best.

The only difficult part of this job is the plastic electrical connector that nobody shows how to disconnect.

If you're having trouble connecting *that* piece, yes you know. It's not the wrong part, you're probably not doing it wrong. I had to clamp that piece with a wrench and push with all the given force in my body. Try to keep the piece as centered as possible, and don't be scared to push down firmly. It shouldn't just pop off, you should be able to pull on it and it stay locked in place. Toodles cuz

Thanks for the video. It looks like someone installed rear camber adjustment, which is why it wasn't the same socket size as OEM. You can tell by the tab on the right side where you slide in the upper strut bolt to the spindle. I thought the rear would be more complicated but glad that access panel is there and the whole trunk area doesn't need to be disassembled.

Replaced my starter yesterday but I took the hot cable off instead of the negative cable on battery. Before putting on the new starter. Would this have made a difference because my car still want start

I have a 2005 e320 4matic. Just got the warning sign “car too low”. Back end sitting low. I am getting it fixed. Cheaper than buying a new car. Only 87k miles

I have 2012 C250, some oil leak come from vacuum pump, I replaced 2 different vacuum pump but still has slight oil comes from back seal of the pump, I bought aftermarket pump not OEM, any suggestions to solve this issue ?

Smart design

hit all the points! well done and helpful!

Was this Bank -1 .???? Is bank-1 on the driver's side or passenger side..????

Kinda glossed over the axle coming loose from the tranny

CTS Cadillac won’t start

08 CTS Cadillac turn off while driving and not start

08 CTS Cadillac starter fuse

Oh yeah I know if you value your Investments and you like to have a truck to drive don't listen to this guy cuz 7 quarts won't just max out your dipstick and fill your oil capacity it will overfill it.! The 4.6 L does not have the same oil capacity as the 5.4

Great video homie 👌 thanks bro ❤

You can’t take it out with one hand?

Thanks bro idk what these comments are about maybe they are thinking of the fuel filter system which is prety much the exact same but on the other side.

bwahahaha you showed nothing and then you act an ass to people in the comments when they point out that you showed nothing.

Does this require a special alternator that communicates with ECU? Probably best to stick with Denso anyway…

What is the hose called that u removed in the beginning of the video?

Good video. I'm having issues troubleshooting a binding steering wheel. New pump, new rack, multiple fluid changes, good tie rods, ball joints, cv axles, and steering shaft knuckle. It still intermittently binds, I'm wondering if belt slippage or trash in the pressure valve? Driving me nuts and customer isn't happy either. 😂 Losing money on this POS.

I thought the ABS module on these needed replaced because of the DOT3 fluid turning to gel leaving the valve stuck open, just asking if you ever heard of this with 2006-2010 Fords

I broke the clip on the connector , I didn't push it in, I pulled it and broke it.. does any one know what clip I need to buy.. I went to the deal and no help there

My light turns on ever time I turn on the truck and then shuts off after 4 seconds is that normal I did change the oil and filter

What tool??

Hello, hopefully you'll see this. Is this the same procedure for the 5th gen 4wd 4Runner, specifically 2016? I read you have to drop the front dif on the 4R,, but it doesn't look like you had to on the Tacoma. Thank you!

I reset mine when I did my oil change and it came on 1.5k miles later do I reset it on A?

Did you disconnect the battery? Thank you so much! (I just wanna make sure)

Is there a plastic starter plate near or around those?

Hola, necesito saber donde se encuentra el sensor TR de un beetle 2005 motor 2.0 automático, espero me pueda ayudar, saludos

Where in Texas are you located?

Dude you kick ass thank you

Thanks. Very helpful

How much of a job like this cost???

I have a bad catalytic convt on my Nissan and was wondt what the cost would be to replace it.

Decent

Good job 👍

Amazing. I’ve done the “pull the glovebox out method “ for years. Thanks.

Dude I’m doing this exactly, but my air compressor is connected with a tube to the thermostat. HOW to you get the black tube out of the way to get the thermostat out

Y you go so fast stupid smh

Is this why there is oil on the downpipe and the left side of the transmission

Thank you for making this video! Answered my single largest question: no, the radiator fan shroud does Not need to be removed to do this job. I'm going to do it soon but with FCPEuro's kit which includes two idler pulleys and a replacement tensioner along with the belt. Remember everyone, torque the bolts to spec! Irritates me that 3 people gave this video a thumbs down; why?

Me and my Husband just tag teamed our alternator!!! We aced it thank you thank you thank you!!!

U suck

How about the VSC, stability/traction and engine light.. all go on and off, but it seems when it gets colder out, it happens, during this summer in Tennessee, it did NOT COME ON?? CAN YOU HELP? MAYBE do a video?

Thank you bro! Bam!

It's easier to take out thorough the wheel well

Got my Aunties off her car after watching this video in less than 10 mins 👌💯 Good Video

4:08 redneck jumpscare