- 16
- 4 433
Rural Retreat
เข้าร่วมเมื่อ 17 ส.ค. 2009
I work on stuff, occasionally throw a tool and generally make a mess
วีดีโอ
September 28, 2024
มุมมอง 16811 วันที่ผ่านมา
Derek Bieri opening the burnout contest at 2024 Duct Tape Drags. @ViceGripGarage
Sounds from the 60fl Panhead. Possibly a wrist pin bushing or something else worse?
มุมมอง 57719 วันที่ผ่านมา
Borescope video of 1960 panhead
มุมมอง 244 หลายเดือนก่อน
checked the compression which is low at 75-80 and then did a borescope look into the cylinders
Trying to figure out a cold hard start condition on the 1960 FL Panhead 
มุมมอง 534 หลายเดือนก่อน
Working on the 1960 panhead. Odd situation this year with it being difficult to start when cold. So far, I’ve replaced the spacer between the carb and intake and have also sanded both surfaces flat, New Viton O-rings, new OEM style clamps, verified timing and points, gap, new plugs, reset float level… It’s an odd one… I start out with no prime kicks and it coughs a tries a few times, then thre...
Same sound from right side
มุมมอง 5596 หลายเดือนก่อน
Trying to diagnose an odd humming and ticking sound
มุมมอง 1.6K6 หลายเดือนก่อน
Carb tuned mostly on the 53 pan in the ass
มุมมอง 1977 หลายเดือนก่อน
Doing some carb tweaking after the idler stud replacement and head gaskets
53 pan start after some needed maintenance
มุมมอง 4037 หลายเดือนก่อน
First start after replacing the idler gear stud and bushing along with correcting stud length for the rockers and new head gaskets. Had to remove the electronic IG and go back to points possibly due to the 5ohm coil.
Bringing the 53 Pan-in-the-ass back to life after over a year of hibernation
มุมมอง 202 ปีที่แล้ว
Boys going to the big game
มุมมอง 977 ปีที่แล้ว
Surprised the boys with tickets to the Clemson/Alabama game in Tampa. They didn't know until we got to Tampa
61 truck bedside #2
มุมมอง 239 ปีที่แล้ว
61 truck bedsides #1
มุมมอง 469 ปีที่แล้ว
I’d have to agree. When was the last time you did a valve lash?
@@natek4139 turns out it was the primary chain. Had some valves recently actually
Joe, you are such a great dad!!!!