- 66
- 19 145
Josh_Stai
เข้าร่วมเมื่อ 14 ม.ค. 2010
วีดีโอ
Viking Josh - Relationships Have Their Seasons
มุมมอง 5หลายเดือนก่อน
Viking Josh - Relationships Have Their Seasons
Viking Josh - Who Am I In A Relationship With God?
มุมมอง 2หลายเดือนก่อน
Viking Josh - Who Am I In A Relationship With God?
Viking Josh - Being A Light To The World
มุมมอง 2หลายเดือนก่อน
Viking Josh - Being A Light To The World
Viking Josh - Grieving...Let God Be Your Comfort
มุมมอง 4หลายเดือนก่อน
Viking Josh - Grieving...Let God Be Your Comfort
My dad my dad had one with t tops.
FYI: If you don't have a manual transmission, there is a plastic plug in the firewall right where the clutch linkage would be installed for a manual transmission (under left side of dash close to the fender). Pop it out and you'll have a inch and a half sized hole that makes it super simple to route wires from engine bay to cabin area. Just drill/cut appropriate sized hole in the plastic plug, route your wires and reinstall the plug. Done! No messin' with windshield required.
Looove this!!
Very well written!
@@darealgreglopez boss music.
Sounds like an awesome Suno mix designed to encourage the Body of Christ. Mission accomplished. 😊
Love this.
amazing .. ❤❤❤
Exhaust set?
@@anthonymolinaro8044 I but the exhaust setup off Amazon. It wasn't brand name. I did a video that showed the parts I used. I did everything but the super charger system. Here's the link to that video. th-cam.com/video/VHDrVipw7RI/w-d-xo.htmlsi=H3NeYN3YL2Jkgoek
Looks good. I ran the control harness inside the plastic pirce that houses the main harness. Just cleans it up a little more.
I hear you, where would we be without God's grace? Happy belated Birthday, and God bless
Windshield won’t budge…I have a sky one touch roof…any advice?
@@Marie-kj3xf Interesting? 🤔 No, I don't have any knowledge of that specific application. But I know you can feed the control wire through the firewall below and then come up the dash inside the vehicle too.
Great explanation sir. Thank you.
Thank you
What are those white clips? Very handy.
They were just some wire clips I got from NAPA. They had 3M tape on the back to mount them. Cheap and easy and still looked decent
@@stiggs4144 Thanks!!
You put the stickers over the handle?
Yep…right on top👍🏻
That staying is sitting perfect
The only way this could be any better is by having a link to the product. Great video. fyi you can also run the wire for the controler thu the firewall on the drivers side.
Thx man! The video was a last minute decision when I went to install it, otherwise I would gone the extra mile producing it…lol. But, I didn’t add a link, because I figured if you found the video you’d probably already found it and searched for an install video as a helper. But yes! You can use the firewall hole to come through as well.
How would you go thru the fire wall!???
@@destineyleigh2848 there is a rubber plug in the firewall were other wires are coming thu.
Video about rubberized undercoat: th-cam.com/video/H2VD5fM6pto/w-d-xo.html
Rubberized undercoating is terrible for a car. It cracks over time and allows moisture to get trapped inside so it will rust even worst. As the original owner of a 2006 Mustang GT I can tell you it came with no undercoating on the underside.
An OG wide body. The only thing I didn't like was the lean burn system, they worked right
Nice! I really like mine. Hopefully, the video was enough to make your install easy!
Thanks for info just picked one of these up today... Going to use it for my emergency lighting on mine.
Did you sell car to guy in quad cities last fall
Any interest in selling?
RARE
Underrated channel for sure man 👍🏽👍🏽
i like that car ..... make upgrade trans 904 to A500. The 1st, 2nd, 3rd is same 904 gears ratio, but 4rd is OD, it's 0.69, more final spd or more fuel millage, point of viuw depends
music to my ears
Has a nice chop, sounds good. Just subscribed to ya. Check out my new edge mustang on my channel. Nitrous pulls coming soon
Beautiful
Thats my bro
YEA STEVEN!!! ITS BEN LLS
beast mode
steven harper-jones is a beast