วีดีโอ

This scanner isn’t made for such small objects like a Battery pack. I have the Einstar too. For such objects I use my Einscan-SP or Creality Raptor. I would recommend a Creality Otter for People only want to buy one scanner. And I would buy a scanning spray too. Aesub makes good ones. I use the orange one. Edit: Are you using the latest version of Exstar? There should be a rewind button.

24:40 Never thought 3d scanning/printing would make me bricked up.

Do you need the top one to make it 2.5”?

I'f you are doing this in 2024. The rear blocks that go on top of the leaf springs are sloped. I was told by a rep a RC that the slope goes towards the front of the vehicle. Just a little bit more information. Great video. By the way, it helped me do the installation flawlessly

Why the back too?

Dammmnnnnn you also got cuter in 4 years.

Great video! Thanks for the detailed walkthrough.

How was the ball joint angel?

Did you need to take it to get a front end alignment?

Exelente. Video u exelente explicación

Looks good

Would you recommend getting the upper control arms for a lift or do you think it is not needed

MIght be a dumb question - if you're strictly wanting to level the truck out, not necessarily "lift it up" at all, do you have to put the rear blocks in? Or can you just install the front components to level it up and skip the rear? Brand new to this - trying to read up before I buy anything. Thanks

Just attempted this install this morning and i installed the lower strut bolts backwards as i couldnt figure out how the hell to get them to clear the cv axle

If all else fails, follow the instructions

I have the same truck but it’s Silverado thinking I’m going to do the same thing . I have 265/70/17 toyo at3 on it wish would of waited and got 285 but it’s going to have to do , 👍 nice truck

I had a third spacer that went under the spring on my strut and I just could not get anything to work at all

I'd give it a F@#$n ten lol

So I got a 2.5 leveling block for the bottom of the shocks. Mzs I’m sure brand don’t matter but they look like the one in the bottom. It didn’t come with the plastic piece on top of strut. Everything is put back together and my front axle rubs on the bolts for the shock up top. Do you think it’s because I don’t have the spacer up top that’s why it rubs? If so do you know what size the top spacer is? The bottom one is a 2.5

What size rims do you have

How much would a shop charge me to install a 2” leveling kit

Video was useful while installing. Thank you for making this video.

whats the angle on the cv axle with this kit

Another stupid LS Vega build. What a waste of a good car! This guy must have more money than sense.

How do you populate the upper Hz cells in the MAF calc. table? Thanks

3:03 look at the Mini-van pull on you, hahahaha.

That thing sounds dirty nasty!!!

How much timing do you think is safe to run on a stock LS based motor?

Do you think, when you weigh cost vs performance, it's better to lift a truck with blocks or with springs?

Seems like a really neat build. The guy you bought it from seems like a turd though.

Great video, but quick question, why is your garage so dirty?

It is Nice to see how good knowladge is put to work. I am more of a Europe style cars, but I see a lot of potential in this build and will gladly fallow along. Take care, and cut the Intro a bit, I think it's too long :D