วีดีโอ

It’s been 6 years it’s your dyi fix still holding up? What is the circuit board number?

BEAUTIFUL!!!!!!!!!!

Beautiful job. ❤️

Mine did the same thing. I'm not sure how long yours lasted, but for mine, that relay that it's soldered to went bad. I had to replace it.

Thanks much buddy. You saved me $200 that I really couldnt afford to spend now.

Oh my God. Thanks for the video!!!!! Just did it and it work.

Question: Reference 2:04 in your video - there's a red component at the top (in the orientation you photographed) and it has a set of two brass prongs beside it to which an off-white connector is plugged (you have it out by 2:04) and that has one black and one red wire coming in. I am having a devil of time disconnecting that connector. I've tried prying from underneath, I've tried inserting the screw driver in the slot in the connector between the two wires (the connector has a split in it) and I've tried prying on the little fin that stuck out towards the edge of the case. I am exerting enough force it feels like I might tear the connector or do some damage to the board. I am wondering if there is any chance that the issue that caused the overcurrent *also* welded the wires inside that connector to the brass-looking prongs. Did you have any challenge getting that connector out? Do you recall how you pried it out? Was it tight?

Thank you sir. I appreciate your video. Our dryer (same one) had this issue and it’s fixed for now. I’m in the market for a new one, but am pleased for a fix for until the new one arrives. Thank you!!!

Slides right off the top onto the floor then yanks the wires out of the user interface unit. I should have recorded that when it happened, like a don't try this at home video,

I have another Kenmore model but used the same control board. Mine had the exact same issue and the burn on the back looked identical. Soldered a wire exactly and worked perfectly! Thank you so very much for the video!

I love this song and her version!