วีดีโอ

Super explanation madam ❤❤❤

Thank you sir , I have a seminar for this and I finally got the answer 😅

highly tough subject😢😢😢😢😢

Best❤❤❤

I think In UTP Q1 is on and Q2 is off In LTP Q1 is off and Q2 is on Plz clarify my dout

Good explanation

if not mentioned 5 sample per sec then?

at last it will be +17 mam

Excellent class sir

thank you sir so much very clear explaination and ppt also very good

good explanation but many mistakes

Nice explanation mam...

Thank you so much mam

Depression me aa gaya video deoh ke

No words your explination was good❤

notes?

Itna bada kyu har lecture ko lakar chala jata hoo...sidha kaam ke baat bola Karo na

25:17 ....|A|= kA/1+AB .....the gain which u have written is for non inverting close loop amplifier....same mistake on Gayakwad.....

Great video, but maybe you could put subtitles in the next videos so we can understand better, but overall great explanation! Greetings from Mexico.

great explanation mam😊thank you

sir teach with energy

Sir how can current flow from ground to emitter node through Re resistor?current will flow from emitter node to ground through Re resistor.i am talking about direction of current through Re resistor.

4z^2/17z^2-2z+1 is the correct answer

Only reading where is the explanation..waste of time..😡😡😡😡😡😡😡

In datasheet the open loop gain of a particular op amp is not given. Please explain how can I get open loop voltage gain . Thanks

Nice. I was looking for input resistance. If Output is directly cnnected to inverting pin (Rf = 0)and R1 is absent,what will be the input resistance? I am using LM741 op amp having maximum bias current = 100 nA . Please .

Mam can you share the ppt

Nice lecture sir

😮

the video is in detail

Helpful thank you 😊

But doesn't open loop gain of compensated circuit increase?

Great explanation sir. I just had one doubt. Sir why is there a negative sign in the output voltage formula ?? Like how is IL in opposite direction to Ic ??

Ulta square wave😂

Sir Jntuh R18 vallaku kuda idhe syllabus ah air?

I think there may be an incorrect minus sign in your formula (Rc(v1-v2)(re-2RE))/ re(re+2RE) @ 24:09.The -2RE in the numerator should be +2RE to allow the terms (re+2RE) in the numerator and denominator to cancel to give Vo=(Rc(v1-v2)/re). I hope you do not mind me pointing this out. Regards

Thank you for you hard work in producing these excellent tutorials. Please explain what you are saying at 24:09 - I cannot quite hear. It is something about substituting an equation but cannot hear which equation. I would be grateful. Thank you.

Very good instruction. I needed this for my current project.

Excellent sir

Great thanks so much

Reading what is on slides

Thank you so much, this explanation helped me a lot

You teaching was clearly understood to me

Do you have an email? I have a question on how to solve some problems I working on

Tqqq sir🙏

Good morning sir

Sir can you this notes for lic 2017 regulation

Thankyou mam 🌹

Where can I get Mpy634