วีดีโอ

مرحبا .. لدي ماطور .. نفس الي في المقطع حاولت كثير ولم يعمل فقد . الضغط في المحرك..ممكن توضح لهذا السبب .. شكراً لكم

I cleaned the carb, replaced the jet, new gas filter, cleaned out the gas tank, reset the system, new oil, added a trickle, so plugs in at night and over winter. It started with button, then died, kick started it and it ran for a few seconds, test rode it around and it died and had to push it home. Cant figure out the problem. Are all Honda Ruckus a lemon from 2009?

Did you do a jumper wire from the service port to the positive lead on the battery? That resets the ecm and the throttle position sensor. That should always be done when changing battery and discounting sensors.

You need the air box and all vacuum tubes connected plus I didn't hear the fuel pump clicking !?!?!?!?!

Hi I’m actually commenting about your garage door opener video. Comments were turned off but I’m having the exact same cable tensioner problem as you were. Door will open but when you go to close it puts slack in the cable. How did you fix this problem? I just installed three of these in my garage and all three are having the same issue. Thanks in advance.

You reset the ECU?

How did you fix the lift master cable tension problem. Your other video doesn’t allow comments

I would think that it is the Bystarter.The wire on the carb goes to it.It chokes the bike when it is cold and the pin comes out when it warms up.You could try to test it and get it working, but you could just buy a new one or just buy a new carb and a new bystarter will come with the new carb

My 2014 Ruck always bogged mid throttle with a few mods. Recently it lost all power, then wouldn't start. I put new oem fuel pump/ filter, new spark plug, cleaned the carb and added new jets, then re shimmed. Wouldn't start. I reset ecu, no go. Then reset ncy cdi and it ran for an hour, then died and left me stranded. Awaiting new carb, and bought a compression test kit and magnetic oil plug. 😑🙏🏻. Definitely reset computer after unplugging/ re plugging anything... from choke sensor, throttle sensor, fuel mixture sensor, gas tank, spark plug etc. Very finicky system.

The carb constant velocity (CV) diaphragm/slide/needle (under carb top cover) can be damaged by carb cleaner which can stop it from moving open when the throttle butterfly is opened. This will cause the engine to die when the throttle is moved off idle. The CV slide must move freely for the carb to function.

I seen a video about a plug next to battery that you put wire into and ground it as you turn on key to reset carb and system

Mine is stuck at full throttle after carb clean but runs mint otherwise lol

Is the contractor replace the broken tiles?

did they break all those tiles during the install ; I would call immediately to get that all fixed at their expense!

What was the decision to add those two panels off on the side roof? Looks like one is shaded by the chimney for a portion of the day.

Dude I have the same problem in 2020 Samsung A21s

Hellonl did you ever figure out what was wrong?? I just cleaned my jets and it ran for 1 min now it wont idle. Brand new ruckus 125 miles on it

Up date...… New carb arrived today, installed and runs better than new! A torch tip file/cleaner is what the lawnmower guys use to clean clogged jets, just an idea.

Thanks for your info.

I just ordered a new carb for my 2009 Ruckus, hope mine runs again.

same issue here

Having the same problem with a 2007 Ruckus except for 2 years started right up I don't perfectly when it was stored. Clean the carburetor that idols and then it shuts off almost like it's running lean

Check the valves shims

Mine does the same thing. Carb was spotless too

Did you ever find out what was wrong.?Having almost the same issue... cleaned carb like 10 times already and have made sure everything looks good. Won’t idle. Can get it to run but it’s hard and takes a lot of throttle

my 2009 sat for half a year. I recently cleaned out carb n jets ,replaced air filter,spark plug,fuses,cleaned out gas tank,replaced fuel pump & fuel filter and new battery and won't kick start NOR electric start either. I'm ready to give up on this shit. very frustrating. I don't know what else to do to it. good luck to you man.

Just got off the phone with HTC Customer Service (consumer) 1 (866) 449-8358. Told me that this is not a "known" issue because it has not been called in and recorded enough times! How many people have to call HTC before they recognize the issue? If you guys all call in, they will fix these as a recall. Got my phone at release and didn't start doing this until a month out of warranty. $170 for them to fix it! This phone sucks. At times completely unusable.

Dahua has great hardware but CRAP, nearly undocumented firmware and software. In other words, just like every other Chinese manufacturer out there. It is not difficult if you already know the answer. Go into the web interface using a browser and type in 192.168.0.108. The you will see where you change the static IP address. The PC software does not do this, it has to be done from the web interface AFAIKT. GL using this crap SW. It is really bad. I'm still struggling to figure it out.

I discovered that the screen problems with my EVO are occurring because of tremendous neglect and the capacitive screen separating. Nothing an insurance claim won't cover.

Wow. The response here shows how truly ignorant people are. I'm so tires of Apple idiots. Yes, the iPhone is a good phone. However, the iPhone lacks hardware that the EVO4G(WiMAX) has, even currently! BTW. Apple IOS runs on a modified Linux kernel as does Android! OSX is an OS! I run it on a "PC"! Do you Apple nuts even know why Apple was once distinctly different? I've had my severely abused EVO take intense abuse and it still works. Now, after 3 years of punishment, my screen is bugging out.

Did you find a solution to your issue with the addressing? I've got a bunch of these cameras, with the exact same switch and never had any problem changing the IP address.

my evo and hero did this same thing

Im the quaterback for eagles lolwe got tossted because dis was our 1st year as a orginization and expirence as a player. I was the best one in my team ,no lie and i know have 3years expirence and gona be my 4th

seriously, no one cares

It looks like I saved myself. I was choosing between the evo and the ns I chose the ns. Lol

are u trying to bash HTC Ur just crazy its impossible to bash something thats Amazing!

pointless..... u just wanted to make a video on the tube

I do have the same issue on my HTC, but only when I'm using a 3rd party power supply... sometimes I have to reboot and a time or two that hasn't helped.

@electric9091 the touch screen isnt shit it works perfect for me

lol the way u touch the screen is so unrealistic..

@blurkoa Dumbass

@DodgeTrucks1500 You are an ass

Stupid spell check that was supposed to be evo.

Gays......my htc eve never had any problems...and trust me I know my evo.

Okay, lets think about this logically. Your pressing on the phones while they are moving on a soft couch? What is wrong with you? Put the damn phones on a solid surface and then test your little experiment. When your standing in front of the phones, all of your pressure will be automatically brought to the back of the phone like we all saw. P.S. if your phone screen was a conductor millions of people would have a day in the park with lawsuits, genius!

@DodgeTrucks1500 well it likes me and i love it

It's like he doesn't know how to use haptic feedback properly. plus, kill some of those running apps. It's probably causing some lag. Overall consenus, this guy needs to learn from his own mistakes before presenting them.

i guess if ur missing a hand and cant hold your phone this would b a problem.. this guy is an idiot.. put it on a hard surface dumb ass

@bucboythug who cares? you are stupid? if i pay a product i want to have it in perfect conditions and without an issues, idiot.

My phone doesnt do that at all...works perfectly fine.