วีดีโอ

In description

Thank you, corrected

Robotic controller

Structural tubes

@@ch3rnykh Omg thank u I generally make my reusable ones 3,75m and use flags since structural tubes bend or break easily for me

Спасибо) скоро выложу на kerbalx

Prioritize your fuel flow towards tanks that have been placed towards the bottom of the craft. Sometimes you may need to place smaller capacity tanks on the bottom to do this. Think of how an arrow flies from a bow, it's heaviest point pulls it through the air as it's falling. This will make take-off more difficult, but you can offset this difficulty with good gimballing engines and lots of control surfaces like fins. In this video by the time he does the flip I bet 90% of his fuel is in the very bottom of the craft.

@@TheEventHorizon909 i heard somewhere that you want to launch your booster with the center of lift below the center of mass, and once you deploy your payload, they should swap places

AtmosphericFX

@@ch3rnykh Is this on CKAN?

I was surprised by that too but it gives you the ability to swing just before landing. Besides they are only slightly in front because most of the mass is already the engines, I use the lower reinforcements in the super heavy in a similar way which are also in front of the center of mass.

Deferred, restock, volumetric clouds, waterfall, tufx

Deferred, restock, volumetric clouds, waterfall, tufx

@ thanks!

Rocket sound enhancement and atmosphericFX

Robotic controller in KSP

Realistic roll, pitch, yaw, engine power adjusts to collective pitch, no reaction wheels

I didn't go for a swashplate because it would be big for this helicopter and unstable. And in fact, the ksp has a built-in swashplate

If you can make a small swashplate for this chopper, I don't mind. We could do a joint craft

Another difference from the real helicopter is the lack of a driveshaft. Other than that, it handles like a real helicopter.

@@ch3rnykh not bad 👍

Почему

Can you send the link please?

@@ch3rnykh my newest v2 demo helicopter isn't finalized just yet but I'm close to wrapping things up. I'll upload and link it on the forum thread when I do. Also, I shall write an accompanying post to show the changes and make the thread better.