วีดีโอ

About 20 -25 ml for two coats.

@@SantosOnTV thank you

@@paulwhite2802 thank you

Hi, In the case of DIY method with the ready to go paint there is no need for primer , the Easy Color Restorer has plenty bonding properties. Overall, I don't use primer unless it is artificial leather or I cannot remove the top coat, A few years ago, when I started, I used primer for every job, and it happened that the paint failed after some time. No problem since I don't use the primer, and I leave the leather to dry naturally for some time between stages. In this case it wasnt service, if its service I use top coat as a separate coat, this was favour. Noramlly My price starts from 200 euro if one seat , then if more than one seat the price is reduced a bit. Thanks for watching .

@@OCDDetailing2021 Thank you very much, sir! I used Colourlock and for few month Geist, too..

@@irinaagnes1250 no problem

Dzięki, powodzenia w naprawie, najważniejsze to się nie śpieszyć i wszystko idzie jak należy. Pozdrawiam

Thank you. For hard leather, after restoration ( minimum 24 hours), I apply conditioner; if the leather is quite hard , I keep the seats for a couple extra days and apply conditioner a couple of times. Usually, it helps a lot to feed the leather and bring back the softness.

Thanks for the response, @@OCDDetailing2021. I have the same seats in off-black/charcoal. They are in excellent surface condition though despite regularly conditioning over the years, being in the sun for hours on end takes its toll and the fronts are hard (but not cracked) and don’t seem to absorb conditioner anymore. As I understand it from your process, I should chemically strip off the top coat, and then apply conditioner until resoftened and then re-seal…? Thanks again!

The product is pH neutral; if you don't have a dedicated leather cleaner, then this product will be a better option than all-purpose cleaners, etc; for real leather, I would recommend a dedicated leather cleaner, but if, for example, it's artificial leather, then the Bonnet will do perfectly.

@@OCDDetailing2021 Thank you! This is bonded leather. Suzuki SX4 Scross.

@@zalanv9490 Bonded leather is artificial, so you can use it for cleaning.

@@OCDDetailing2021 Thank you very much! 🤗

​@@zalanv9490 no problem

Thank you very much!

Can you send me photos of the seats to hello@ocddetailing.ie , I will be able to give you quote. Regards. Peter

@@OCDDetailing2021 how much for these two which you used in your video?

Hi, unfortunately I am not sure about the colour code, we match colours ourselves to the actual leather so we get the proper match.

@@OCDDetailing2021 thanks anyway

I know, I don't do that anymore in my newest videos

Ths for watching

Yes , it's kind of grabby, but once the excess is removed it's nice and smooth

Thank you😊

Thank you 👍 Спасибо

I cant remember, we mix the colours ourselves , so overall we don't search the color code for that as we just check the color on the actual leather.

Thanks for watching Andy, Best Regards Peter

Nakładałem wiele powłok, Grafen z Aqua nie jest najłatwiejszy w aplikacji, przy wyższych temperaturach powiedziałbym , że jest dość problemowy. Jeżeli chcesz dobrą łatwą powłoke to Cleantle Admire jest super, albo FX Protect G Finity CNT , również łatwo się nakłada.

You are very welcome, thanks for watching and best of luck with your seats !

Thanks for watching, when you disconnect batery in older cars it will reset radio, so you need the code for radio if it has the code. If there are electric seats it may reset the setting etc. Other than that it will be fine, after dicounecting the battery , turn on lights or something to drain the system fully and wait couple minutes before disconecting the seats. Normally i don't disconnect the battery, and 99 % times is fine, fault comes on the dash if the car is button stop / start, so for these you are definitely better of to disconnect the battery if you don't have diagnostic tool.

Thanks for watching !

Thank you very much!

Thanks for watching David. I have 2 videos about leather restoration but just need to edit them.

Thanks William, I am glad you like the video, the 9mm adbl polisher for someone who does it as a hobby I think is perfect.

Thanks Michael, I think I will stick with the ADBL Beetle Juice for the 🪲 . 😂😂😂

Dzięki , przed każdym nagraniem jest trema, ale z czasem mam nadzieje ze będzie lepiej. Powodzenia z naprawą . Pozdro

Its coated

​@@OCDDetailing2021 Thanks. I ended up ordering a set of the new Work Stuff (Thunder and Blizzard) brushes, along with the DI Brushes Speed Master Sr (the Jr was sold out). Just to compare and try out. I have almost the entire line of all the different Work Stuff detailing brushes, and I love those...so I doubt these will disappoint. But we'll see...

I use a lot of Geist products but also Colourlock , I have topcoats crosslinker , check my website www.ocddetailing.ie

Thanks

Glad I could help!

Thanks

@@OCDDetailing2021 🤝👍

Thanks Owen, I am happy the product works well for you, Peter/ Piotr both are correct :)

@@OCDDetailing2021 🫡

Thanks for watchine anyways

Thank you

Dziekuje i pozdrawiam

:)

Its not difficult

Can do anything you put your mind to!

Thanks

Hola, no estoy seguro de qué parte del proceso estás pidiendo, en el video utilizo limpiador de cuero, solventes, pinturas y algunos productos más.

Thank you very much, i am glad my content is found helpful😊

Thank you

When it comes to polished aluminium , this product may cause reaction, if I clean tires on wheels like that, i spray the product on a brush agitate it , then rinse it of f, so the contact of the product is minimal with the alloy itself

@@OCDDetailing2021 Good point with that spraying on the brush technique. Thanks

​@@danr8472no problem

Thank you very much. If you are in Ireland it can be done.

Thank you. You can still do it without the gun; you can dab the paint; it will be a more time-consuming job, but for one seat, getting a gun and a compressor would be overkill. check this video th-cam.com/video/JeCyjYo_TZU/w-d-xo.html

Thank you

400 gradation

Thank you