วีดีโอ

You can request the VSD to complete a motor ID by going through primary settings wizard. Select motor and ID Run, then go through the wizard to the end. By doing the ID run this way, there is a screen displayed the whole time while the ID run is in progress. Press the start button, and the VSD sends current to the motor at a small voltage to measure the resistance, capacitance and inductance of...

You can request the VSD to complete a motor ID by changing parameter 99.13 to the type of motor ID required. This activates a warning stating "Motor identification run about to be performed". Press the start button, and the VSD sends current to the motor at a small voltage to measure the resistance, capacitance and inductance of the motor and cable run. At the end you need to get the tick with ...

Switchgear ABB Offer

Switchgear Direct Overview of some of the items stocked

ABB ACS580 4..20mA 0-10Bar Pressure Transducer Start, Stop, Pressure Setpoint Via Control Panel

Generator would stall when attempting to start a motor with no load attached. Installed a soft starter, and generator would only get the unloaded motor away sometimes, peaking at over 50A current. Installed an 11kW ACS580 IP55 VSD. Current maxed out at 3A on generator.