- 4
- 23 228
Jeremy Kern
เข้าร่วมเมื่อ 3 ก.ค. 2012
WVU Pride of WV Marching Band Buckwheat 2023
WVU Marching Band 2023 at Buckwheat in Kingwood WV. Video Nikon D5500 with R0DE shotgun mic. This video/audio is raw with no editing/filters. My wide angle lens wasn't quite wide enough to catch all the kids all the time, and the auto focus was a little slow sometimes. Video is OK, but the audio is pretty good! Listen on good computer speakers or audio system.
มุมมอง: 2 101
วีดีโอ
WVU Drumline Buckwheat 09 30 2023
มุมมอง 24110 หลายเดือนก่อน
WVU Drumline practice at BuckWheat 2023 in Kingwood WV. Video Nikon D5500 with R0DE shotgun mic. This video is raw with no editing/filters.
Yamaha Wolverine 350 ATV Quick Starter Replacement
มุมมอง 3.3K3 ปีที่แล้ว
This a how to video for quickly replacing the starter motor on a Yamaha Wolverine 350 ATV. Yamaha used this engine on quite a few different models, so the video is applicable to many ATV's. This video shows the tools and procedure required without removing the plastic, fuel tank, or carburetor. With parts and tools previously sourced, this procedure can be completed in under 15 minutes.
Ram Carrier Bearing Replacement
มุมมอง 18K4 ปีที่แล้ว
This video was made to show how to replace the carrier bearing on a 2011 Ram 2500 pickup. This should also work with the Ram 3500 series trucks within the same body style.
Did you reinstall a new race in bearing ?
I love all bands, big or small.
very cool
Thank you for this Video. You actually showed most of the steps so that was GREAT.
Good video , 1 thing I’m not seeing anywhere is the actual drop bracket orientation for the carrier bearing. Some guys may snap those bolts off & have to remove the drop bracket & if it’s in a backwards orientation that will definitely cause problems since it’s angled.Great video though!! 👍🏻👍🏻
Good video. 👍🏻need to replace the carrier bearing on my ram soon
Awesome vid thank you, God bless
Do a video on how to clean the carborator
How big was the pole you used to press it in
Just a piece of pipe I had handy that fit over the end…I am guessing it was 1.25” x 3 ft long or so.
How many hours need to finish work??
I think I did the whole job in about a hour.
You never showed the clearance for the front of the bearing and drive shaft
I am not sure what you are referring to...I positioned the new bearing tight against the machined should like the OEM one. Once back under the truck, lined everything up and installed bolts loosely to ensure fit before tightening.
@@jeremykern9071 you said around the 10:00 mark that you needed to double check your clearances…how do you know what the “clearances” are supposed to be?
Wow thanks so much for your post. My 350 is a few years older, but looks identical to your engine. Going to make my job way easier than I anticipated!
Can you post a link to the puller that you used?
I used an OTC 1036 puller from Amazon. www.amazon.com/gp/product/B000O8243Y/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1