- 115
- 724 861
Benson Yu
Canada
เข้าร่วมเมื่อ 25 มิ.ย. 2013
www.bproautomotive.ca
Hi I would like to share my automotive repair video with you guys.
Also I will do some car reviews if I come by nice car :)
Hi I would like to share my automotive repair video with you guys.
Also I will do some car reviews if I come by nice car :)
Cayenne Fuel level not correct? Try this first !!!
2012-2018 Cayenne fuel level sensor DIY
Car has 2 sensors
Recommend replace both sensors
And before you put back the seat
Make sure add gas to car make sure fuel tank does not leak
Car has 2 sensors
Recommend replace both sensors
And before you put back the seat
Make sure add gas to car make sure fuel tank does not leak
มุมมอง: 204
วีดีโอ
BMW X5 Chassis fault code ??? TRY THIS FIRST !!!
มุมมอง 4434 หลายเดือนก่อน
2016 X5 chassis fault codes ? Comes on and off Check the rear suspension air bag If leaking replace BOTH airbags and road test Likes and subscribe if that solved your problem Thanks 🙏
2016 BMW X1 Engine Battery DIY step by step
มุมมอง 2654 หลายเดือนก่อน
2016 BMW X1 engine battery replacement
Porsche Oil Pressure problem ? TRY THIS FIRST !!!
มุมมอง 1.8K6 หลายเดือนก่อน
2016 Porsche Panamera GTS Oil pressure light is on Replace the oil pressure sender Make sure use a scanner to clear the fault codes after !!
New Porsche 911 (992) Dash cam install DIY
มุมมอง 9646 หลายเดือนก่อน
New Porsche 911 (992) dash cam install DIY The cigarette light will shut off after couple minutes after the car is locked Please ask any question down below, I will try to answer asap #992 #porsche911 #dashcam
Toyota runs rough after battery replacement ?? Try this first !!!
มุมมอง 816 หลายเดือนก่อน
2003 2004 2005 2006 2007 2008 Toyota B battery replacement Car runs rough Idle poorly Car stalls Idle relearn failed Try this first Clean the throttle body and try again !!!
2018 -2024 Mercedes Benz G63 (W463) air filter DIY
มุมมอง 6107 หลายเดือนก่อน
2018-2024 W463 Air filter DIY Tips and procedures Not that left and right air filter is different size and different part number
Mercedes GLC300 GLC43 Auxiliary battery location and DIY
มุมมอง 3.1K7 หลายเดือนก่อน
New Mercedes auxiliary battery location GLC300, GLC43 , C300 Part number and DIY
2018 BMW 530i evap canister replacement ( b46, b 48)
มุมมอง 2588 หลายเดือนก่อน
2018 and up BMW evap canister ( evap filter ) replacement Costumer had a concern about car doling after cold start. Found evap vent valve was leaking and created vacuum leak. And found that evap canister was contaminated with gas. Here are some tips for the evap canister and the connectors.
Ram 1500 Brake light Problem
มุมมอง 13311 หลายเดือนก่อน
Mysterious brake light problem. Coming from Germany car background. Please share around the information 🙂
Evoque hard to pump gas FIX!!!
มุมมอง 11311 หลายเดือนก่อน
Evoque hard to pump gas, gas pump keep jumping. Solution is to replace evap canister
2013-2018 X5 F15 sunroof drain cleaning tips
มุมมอง 7K11 หลายเดือนก่อน
2013-2018 X5 F15 sunroof drain cleaning tips
2017-2024 Panamera 12v fuse and dashcam tips
มุมมอง 2.3Kปีที่แล้ว
2017-2024 Panamera 12v fuse and dashcam tips
New (2018-2024) Porsche Cayenne cigarette lighter fuse DIY
มุมมอง 4.8Kปีที่แล้ว
New (2018-2024) Porsche Cayenne cigarette lighter fuse DIY
2014 -2023 Mercedes gas smell in cabin, DO THIS FIRST !!
มุมมอง 13Kปีที่แล้ว
2014 -2023 Mercedes gas smell in cabin, DO THIS FIRST !!
2015 Land Rover Sport 5.0 oil change DIY
มุมมอง 401ปีที่แล้ว
2015 Land Rover Sport 5.0 oil change DIY
2021 Mercedes EQS cigarettes lighter fuse location
มุมมอง 835ปีที่แล้ว
2021 Mercedes EQS cigarettes lighter fuse location
The most power 7 Seaters in the world, 2017 GLS63
มุมมอง 153ปีที่แล้ว
The most power 7 Seaters in the world, 2017 GLS63
2017 S63 oil change DIY (4.0 twin turbo)
มุมมอง 1.7Kปีที่แล้ว
2017 S63 oil change DIY (4.0 twin turbo)
2016 GL550 front brake replacement (brake and rotor)
มุมมอง 1.3Kปีที่แล้ว
2016 GL550 front brake replacement (brake and rotor)
2017 S63 cold starts and luxurious interior
มุมมอง 57ปีที่แล้ว
2017 S63 cold starts and luxurious interior
2018 Panamera 4 cold start after repair !
มุมมอง 362ปีที่แล้ว
2018 Panamera 4 cold start after repair !
Is it work on 2015 e300?
Thank you for the video! Do you have to calibrate them after or are they good to go right after installing? Do you have part numbers for the gaskets that you have to replace?
I used a scanner to cleared the history fault but it worked right after I replace it , the gasket I need to check later
Torque specs 30 NM ??
does any one what is this code codigo c221500
I wondering if that canister leads to the detection pump module
thanks man, this really worked for me today👌🏽
@@timothyangel3968 all good hah
How did you fix the clamp? Did you take off the old one (if yes, how, without damaging the hose?), or did you just place the new clamp over the old clamp?
I remove the old clamp and install a new clamp , just be gentle when you remove the hose
@@BPROAUTO95 Thank you!
Hi. Is this a voltage converter or auxiliary battery?
This one is purely a battery
My Audi blows hot air and I got told there’s compressor was bad would this help fix it? It’s also stuck on Econ mode idk if that’s a symptom
Unfortunately no, the compressor itself it’s another faulty part, need to replace fault part so the car will work
@@BPROAUTO95 ahh okay I see
That fuse is 40 amp?
I think it was a 20 amps
When the wire went though the A pillar, will it somehow block the airbag from deploying?
@@kakitling2191 those are gun powder in airbag,should be okay
Found same on way to buy new jubilee clip
Nice haha
“Don’t break it”! Got it. Thanks.
@@PH-md8xp ahah the BMW only wants 8nm on the bleeder screws h
Yes, I think this is the correct fix. Everybody goes and replaces the rubber hoses. Rubber fuel hoses don't deteriorate so fast and so consistently. It's just a clamp defect issue.
Haha my little experience for your guys 😊
lmfao! little 2.0 q5 with rice exhaust lol.
Put bread
Hi do you know which fuse is for the right hand headlight? Thanks
Trying this after work today! Fingered crossed it works on my cla 250 🤞🏼
@@stephanievee1617 haha please let us know how it goes 👌🏼
What is wrong with your cluster? My 2016 mb cls 250 has a bunch f lights on the cluster… lmk if it fixes something pleaseeee
I just felt that I need to give an update. Hello Guys! I had the same problem for the past two days. I tried all these methods but it didn’t work for me. I continued driving the car with the same problem. I put on the ignition so as to drive to the mechanic workshop and boom!!! My dashboard was back again😂
Code 7900 c class 400
Hello
good video, how do u put the bubble? fron outside? u manage to fond tje leak?
I jacked the car up and spray soapy water made from dish washing soap haha
Se quedaba abajo la rueda a las pocas horas? Y salía fallo dynamic damping control?
Im about to get a muffler delete on my 2018 q5 should I delete the resonator? And should I get downpipe or straight pipe? I need help gang
My cig lighter stays on forever... I wish it didn't
I have a battery pack that provides power after I turn off the car. Which is why I don't like the cig lighter permanently being on.
@@xiingliI believe you can go to dealer and get a software update, it will shut the power after
Hi did this solve the issue. I have the Oil pressure too low warning also Fault oil pressure monitoring? 2011 V6 3.6 P4 166k mi
@@rjules777 try change sensor
I would like to know the price and where can I order it. Please reply me.
www.bproautomotive.ca My website ✅
Replaced switch now ac button light wont stay on lol Compressor still not engaging and low side and high side pressures are both 125 static so it has freon
Do you have power at the ac clutch connector ? 😊
@@BPROAUTO95 compressor on the audi q5 have no clutch is variable displacement
@@2jzgenat 2018 this video can not be applied, different system 🥲
Bro your a life saver been battling with this for too long than you
@@alihenderson1362 no problem brother ✅
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
In my case I got lucky. It was just the fuse
That’s good hah, cluster never really go back ahah
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
My website ✅ www.bproautomotive.ca
Hi, Where did you get that adaptor, I got a Vevor extractor and need the adaptor.
I got it from Amazon mityvac oil extractor
is this actually a 2017????
@@-blank-2523 yes
Remove the negative cable when engine is NOT running, sorry for the confusion
Do we take the negative while the car is running or no ?
When the engine it’s NOT running, only ignition on
Good info. ...and good info (comment) about having ignition on but not engine running.👍
Thanks for the video! Unfortunately, this solution alone didn't solve my issue of the instrument panel not working on my 2009 c300 (w204). What solved it for me was removing the instrument cluster and unplugging it in the back while the engine was off, then putting the key in the ignition to the on position (engine not cranked), and then replugging the instrument cluster back in, and voila everything turned back on and is back to working normal.
So you did a hard reset on the cluster, nice 👍
Thanks! Your video helped me solve my issue. Somehow the passenger side drain got disconnected. Still scratching my head on how it got disconnected. Thanks to your video i was able to access it and reconnect it (with a zip tie this time). I did a little maintenance cleaning using an air compressor like you did in the video. Thanks again buddy. Potentially saved me hundreds if not more!
Omg, that’s my first super thanks!!!!! Thank you so much for the support Motivates me to do more videos Glad that it helped, Thanks again for the support !!!!! 😊