วีดีโอ

09 legacy and put hid kit in. Boxes are similar and that spot says drl rear and is empty???

Thanks for the easy fix. Passing for info that I found on the fog light wiring in the comments on the fog light video.

Put the same kit in my 2012 Legacy. Popped the whole bumper off to do it and found that the subaru factory wire harness already has pigtails for fog lights tape under the headlights. After doing some research I was able to wire the switch from the kit into the factory harness. Clean up the ends on the pigtails. Surprised the salt didn't eat them. Put a relay in the factory spot and they work just like factory. They only come on when the headlights are on and turn off with the high beams as they should. All you have to do pop off the panels to get to the underside of the steering column to get to the plug for the turn signal. There will be one side with a black wire and a 5 other colored wires that control turn signal, parking and high/low lights. The other side had one colored wire off to the side and a black and white in the center. Can't remember all the colors but that doesn't matter because it the black and white in the center that control the fog lights if equit. I spliced the switch from the kit into those wires and everything works fine. Even the fog light indicator light on the dash works. Just didn't wire the the light in on the switch because it doesn't match. Not sure if doing so would cause any problems. Found your videos looking how to turn off my daytimes so I can run just my halos instead. But still have high beam. Thank you for the info on the easy swap out the relay fix. Figured I'd pass this info your way.

We can hear u well

just did this.switch wires are close to were you were.wrapped in a reddish tape.relay was next to the heater blower motor by glove box.wouldnt have found it however without watching this thank you I learned something.great video.i apologize for my last post

wasted 18 minutes to hear wiring is done.dont waste your time...

It looks like a ball joints falling off the Beaver dam golf cart

This my next mod along with a new lip , also apple car play with new speakers and I’ll add my two 12” rocksforge fosgates

So I have a 13 legacy 3.6r and I’m doing all my light replacement hi/lo and fog light to a 3000k led . Have you rewired your fog lights to be drl yet ?

Running fog lights as drl is something I wanna do

I replaced 5 prong relay with the relay above but did not work. My Outback is 2009, any ideas?

where did you buy the lights? i want two for my subaru 2019 impreza hachtback

I get flashed all the time too lol, did you have fun putting the low beams in? What a oain in the ass, i finally paid a garage to do it and they even bitched about it

Is this a legacy?

Where did you get your components?

Thanks that really helps me out 😊

'Promo sm'

one crusty mofo

Speed holes