วีดีโอ

Glad it helped. they sure seem to come undone too easily

Unfortunately I don’t have the wiring diagram for this car so I don’t know for sure. Sorry

Here's a link to it on Amazon - amzn.to/3upVsXD but really any pump should be fine. I prefer the ones like this have a hose where it connects to the tire.

Thank you

Hi Victoria. Sorry but I do not have any Else Doll's to work on

Hey Does the LE come with factory wiring? Idk if u done it already

Ok

I think you need to replace the switch on the steering wheel too , if you want to use the factory plugs. But that may not work either . I’m still trying to figure that out . I’d like to use the factory plugs , since they already exist , and i have a hybrid so that box where he put the switch is already taken

Check your turn signal. Should be a rotating collar to the right of your headlight control. Should indicate green fog light above fuel gauge when rotated. Hope this helps. Only activates when headlight are on.

Jiateng Wang Fog lights were designed for fog but can also be used for additional light where desired. The wire harness comes with a switch if you want to hook it up. My wife just wanted them on anytime she was driving at night.

Kendry Rojas I believe it would be the same kit

Ken Swenson no men its longer the se version I bought I regular fog ligths nothing . And in amazon dont apperence

Kendry Rojas there is a adaptor part that goes on the front to make it from rectangle to round. Then on the back side of the bumper there are hole to bolt the sound lights to. Did you watch the whole video? I tried to show all of that in the video. It doesn’t look like the right parts at first but it works out

That’s a good question. I didn’t end up using the factory wiring so I didn’t research what it would take. Being that they seem to have pre-wired it I think a switch and fuse would be reasonable for what is needed. You would need to find a wiring diagram to see what is needed

Mr Sakapfet509 exactly correct. And the ground wire just went to a screw on the frame that was convenient to where the harness worked out to be

Ken Swenson ok so I get the whole you splicing into the headlight but what happened to the original positive wire from the headlight connector? ( basically I see how you worked it to power fogs & headlights but I’m curious as to how did that specific headlight power on if you spliced it’s positive wire the brown wire)

The power wire still goes to the headlight. I just tapped off of it to also be the trigger for the relay(rather then going to the supplied switch) so I didn't overload the headlight circuit. The main power come off of the fuse box and is fuse protected.

Ken Swenson hey just wanted to say Thank you because I followed the way you did the fogs & everything went smoothly ... my only concern is that it seems like the car is idling(shaky) heavier overall just really shaky I made sure to tighten the battery terminals

Mr Sakapfet509 the car shouldn’t shake. Does the car still shake when you turn off the lights? The only time I notice the shake on my car is at idle with the AC turned on

anglngr9 if I had used the factory wiring I would have needed to get the factory fog light switch. For this car I just wanted them on at the same time as the headlights were on, so this just made it simple and I didn’t have to buy ant additional parts.

there seems to be some missing instructions on how you wired that version: using the head lamp browm wire?

Joseph M. Fernandez sorry I missed your comment. The brown wire is the power wire to the headlights. I used it to trigger my relay that way there’s no extra load on the headlight circuit. Could also do it on the running light circuit if you want them on without the headlights

Some cars are missing the relay and 3 wires under the dash. Conector II pin 3 needs to goto pin 4( this provides power to foglight relay. Connector IL pin 8 to ground (normally the ecm would provide this ground if you had oem Fog Light stalk). FogLight will be on all the time. So I connected wire from connector IL pin 8 to aftermarket button then from button to ground.

Bobby Clemente I’m glad you found it useful. Hooking it up to the lights made it easier for my wife. Just make sure to hook the main power wire to the battery and the relay input to the headlight power wire so you don’t overload the headlight circuit

I bought a H11 Splitter and H11 extension cable and plugged it with the headlight. Seems to be working so far. Will it have any issue with fuse?

Jeremy Berney so I just hooked to android phone to it. I’m running verb5 of the app and I updated the firmware on the drone too. Still feels the same as my iOS

Don't buy one. At least not yet. GPS does not work yet. Flight performance is poor. We will see what future updates bring....

I will try to get some footage today hopefully and upload it

any progress with the iphone working better with the new updates ?

After the last update I can’t even get it to connect anymore with iOS. Android still works but also still poor performance.

howd you connect via iphone ive been having trouble with that?

Glad it helped. Were you able to shorten it and get it reattached?

I was! Thank you again!

Minka Gaston, I'm glad you found it helpful and I hope this helped you to get yours back together