วีดีโอ

I refinished the existing nonskid with new Kiwigrip.

Some of the final preparations for primer on the inside of the boat. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

I applied six coats of varnish to complete the brightwork project. Masking took parts of two days, then one coat of varnish per working day, and another day to unmask.

Preparing numerous small parts for installation. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

In this video, I cover the steps required to finish off the CNC-milled plywood foils for the sailing kit. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

After stripping comes sanding, which I completed over two days of work.

Over two days, I stripped what remained of the varnish using a heat gun and scraper.

The owner of this boat wanted the ability to use an electric outboard, so I made some modifications to the stern. The designers of the boat were not in favor of outboard use, but did offer some general guidelines in the manual, which I followed in the same spirit. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

This video covers several weeks of progress on the hull exterior, from filling and fairing to fiberglass and fill coats. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

Installing the foredeck and some related work. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

The bulkheads required quite a few steps to finish them and prepare the boat halves for the next steps. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

The aft tanks began early in the project and took many different steps to complete. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

After gluing in the connecting hardware, it was time to finally cut the boat into its two component parts! This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

Installing the various components of the mast step. This is not a step-by-step tutorial. For more detail and build information, please visit below. lackeysailing.com/projects/pt11/

PT-11 Build #14: Glassing the chines

PT-11 Build #13: Main bulkhead gussets and fillets

PT-11 Build #12: More pre-installation work on the foredeck

PT-11 Build #11: Daggerboard Trunk

PT-11 Build #10: The Main Bulkhead

PT-11 Build #9: Hull Chine Fillets

PT-11 Build #8: Foredeck assembly

PT-11 Build #6: Hull fairing and seam detail

PT-11 Build #7: Forming the stem

PT-11 Build #5: Transom, inwale, and fillets

PT-11 Build #4: Final seam tweaking and gluing with epoxy

PT11 Build #3: Gunwales

PT-11 Build #2: Assembling the Hull

Cape Dory 31 Danusia #1: Initial Brightwork Tour

PT-11 Build #:1 Glassing and coating the hull panels on the bench