วีดีโอ

Unde aș putea găsi bateria model vc889rs

Pošto mešalica

IF YOU DON'T SHOW HOW TO OPEN IT'S USELESS

El cargador tiene k ser de 48v no vale uno de 36 de Xiaomi k tengo tomas de Xiaomi

Gonzalez Patricia Taylor Michelle Clark Jeffrey

eine frage bei den Akkus von Bolt geht der Akku nach 10 Sekunden fahren aus gibt es da eine Lösung ?

Добрый день! Не подскажете 3 провода тоненькие куда подключать

Сколько 70 есть?

Thanks 🙏

😂😂😂

Top speed?

hi just a question my battery cuts off as soon as the scooter is under load is this a solution

How in the world did he get 54v output? I can only get 18v. Please help!

Hi sir

Do you have a partnumber? I have a problem with the exact same chip, but can't get a replacement part because a of a burnt number

Gdje je servis vaš,i gdje mogu nabaviti nove baterije za ovaj usisivač.

The problem with discharging the only way it 's to change bms

hi, I followed your tutorial, everything is fine but why does the voltage go back to minimum if I connect something?

Can you change the discharge plug too?

Burn out😂😂😂 same problem with me

What is the total price of full restoration ?

Što da ne,vidoko mu usisna grana tojest filter za vazduh a to je najbitnije.

What liquid and cloth did you use to clean the screen layers? Thank you

😂👍🚢

CAR 😅😅😅

pa ode bus na odpad

Can you pls explain which wires you connect. I have same battery but I can’t get it to charge & give output over 4.6v

Is this just for the charger or to bypass the battery i have done a diffrent bypass an can get 44v but need to be able to cxharge now battery works fine on bike

I have the same battery but cuts out on full throttle

To si ti nešto sjebao

Hey man had a question for ya. I ended up taking off the wires for the battery screen and was wondering if you had a picture of how they are supposed to go.

Koji je ovo smrdljak od grada kada imaju reku na putu😂

How do you charge the batter and active the screen

Hello Andreas! There is a burn capacitor in my G2 tower. I want to buy it and sold it in order to fix it. If I send you a photo of the mobo can you recognise the info of the capacitor so I know which one to buy?? Thanks

How did you enable the output??

Ни так так бы сразу показывали китайцы, для сварки стали 0.8 надо 220 ампер, только на видео металл перегрет

can you use any reasonable 26V supply?

Good day sir. I want to ask a question and it is this, can a system still work if a component is shorted to the motherboard. Have been experiencing a issue with my system when used with the battery it works for two days after that it will refuse to power on not until I remove the battery for one day before it works again, at this moment it refuses to on nothing I'll do will make it come up not until I wait for one day.

The buton its stacked whit glue mast pull hard

I know this is old But phew, it gave me confidence to do it to my Legion 5 lcd, Success operation 🎉🎉🎉

Where can I repair my MPF Drive? Thank you, Joesoef. The Hague, nl

Did you pry the bottom out ? I removed all the screws but it's still stuck

How do you open the unit?

Hey I have a ProBook 650 G2 HP laptop and it stopped charging, I was using it and saw that it's low so I put a charger in and it was charging fine until it suddenly stopped now when I try to hold the power button for a few seconds without the charger in it flashes an orange color on the led but when I put the charger nothing happens but turn on at the caps lock button please help

Hi. I need a picture of the psid section please if u have

What if the outside screen got gracked can it be replace if yes please how

What liquid do you use to remove the glue? Regular lighter fluid? ;)

i added a FHD cable and installed a 1920x1080 screen. totally awesome now, but was more work than i thought it would be. Had to completely disassemble it...

Višak delova :-)

IT DOESN'T WORK , the only good technique is to change the BMS, cut open the case and change the BMS, it's tedious and takes several hours...