- 27
- 61 021
FoKing Garage & Shop
United States
เข้าร่วมเมื่อ 5 พ.ย. 2013
วีดีโอ
Warming up the probe
มุมมอง 737 ปีที่แล้ว
Just a quick warm up, going over the car a little bit. I can't wait for the warm weather to come back so I can finally finish the car.
02-08 Mazda6 Double Din
มุมมอง 11K7 ปีที่แล้ว
This is a slightly old video, but this was installing the then pre released metra double din kit. I couldn't find any information on the forums about it so I spent the money and got it I believe first installed on the car. On Ebay my car is in the pictures they use.
2014 Seahawks Superbowl Parade - Beast Mode
มุมมอง 117 ปีที่แล้ว
2014 Seahawks Superbowl Parade - Beast Mode
Mazdaspeed6 10.488 @ 120.26 3rd gear maxed
มุมมอง 9689 ปีที่แล้ว
Mazdaspeed6 10.488 @ 120.26 3rd gear maxed
Setting the display on a metra kit. Mazda 6
มุมมอง 16K9 ปีที่แล้ว
Setting the display on a metra kit. Mazda 6
Class action Lawsuite should be held on Airlift manifold.
How you replace it ? You just take it out?
Yes, you buy a replacement fitting from bagriders and with a hammer and flathead your remove the old one.. use a socket and a hammer to put in the new one.. there are youtube videos on this.. Ive done it and it works.
. Then replacement goes bad also😅
I'm no guru ,but on mine I needed about 4-5" of straight line going in with no side loading. And the grey collar slid out pretty far, I had a couple leaking at first. Yes I cut the lines with the nice supplied cutter. Edit : from the top of the pic, the 5th one down is how all my gray collars look as far as distance out.
How to fix please?
Re-cut the end of the line (1/2" off the end with very sharp cutter tool). If still leaking you need to replace the SMC cartridge. There's YT videos on it, I just did it yesterday and it worked.
To fix it you just have to cut a little bit off the line. I kept pulling it out the quick connect and some of the rubber wore of which was causing the leak and I just cut a little bit off the line and it worked fine again
if that doesn’t work then u need to replace the cartridges
Saviour
Mine is leaking letting the drivers side rear bag fall, were u able to fix it?
*Did You Fix It? Same ... Mines Driver Side Every Morning Its Down*
@@chiefgwopp1004 ended up replacing the strut bag and ran a new air line to it.
@@D13_antraxsicario_CDS *You Could’ve Just Replaced The Straight Cartridge Brotha , That Sounds Like A Lot More Money* 😣 *Damn 2 Years Later, You Still On Bags?*
What's the t and e connections for?
Steves Modz The T stands for the line from the Tank E Stands for exhaust so when you air out it’s where all the air goes out
Dang I'm having this issue I think & I'm guessing this isnt something you can repIr on your own :(
It is. But can be worrying because you have to take a hammer to your $1k manifold haha. Just replaced a leaky cartridge yesterday, went smoother than expected and no more leaks now.
Its Not a metra dash its a Carav dash Kit LuL
Where you able to repair it ?
What air kit are you using
we're can I get the cams at?
How did you get your upper LED screen to work with aftermarket radio? I just put in aftermarket radio and my led screen is just black
I got the Same Problem 😂so i Chance the LCD Display from 2004 to an 2007 also install the LCD from FL in my pfl and Change my Radio 😂if u like Visit me i will upload a video as soon ✌
@@CoD2Show did you really? You would be a hero if you could help me with that! I have the same issue that my screen turns black after replacing the radio!
How have you connected the cable? Perhaps you have still images. Would be real👍
Cody Grenz I've got no instruction to do so. that's why I asked.
How did your speakers sound after an aftermarket headunit upgrade? im planning to swap speakers aswell.
carav 11-106 ❓
doesnt the metra kit have a different design with all the buttons on the sides of the double din?
Cody Grenz m.ebay.co.uk/itm/281896971863?_mwBanner=1
Cody Grenz Just saw somewhere that the eco mode didnt work. On my mazda 6 06 the ac button has 3 stages "off - ac - ac eco". Do your ac eco mode work with the kit?
Cody Grenz forum.mazda6club.com/#/topics/257045?page=1&_k=jytt5f
dead link? only leads to forum, not post
What is this for a panel❔
Check all bolts and nuts first but if there original they are probably shot.
What type of radio did you put into the metra kit
I had to leave. :/
What upgrade on the 6?
Amazing!
nice!!!
Dude that sounds nasty
Hey man, I see you have the same kit as me. I installed it in my Mazda 6 2004 hatchback with Bose and I cannot get any sound. I bought a PAC interface so I can get use the stock amp and speaker but I'm stuck with RCA cables which I have no idea what to do with it. Is yours Bose by any chance. If so, I'd appreciate any tip on the RCA cable. Thanks.
Did you ever get this fixed? Or did you have to get a whole new manifold? My manifold is leaking the same way.
Juic85 I'm having the same issue, we're you Abel to fix it or just had to replace it?
Juic85 take it back they'll give you a new one i used to work in the lab making those 😊
vaitiare Silva if it’s not under warranty still, are we out of luck?
vaitiare Silva help
mine is not under warranty and it's doing the same thing now what shuld i do?