วีดีโอ

Need mount kit in swingarm ktm quad. can give me sequence of pieces? tanks

heads up on the 2017 I have, the PDS bushing in the swingarm does have a small lip. So be careful when pressing it out that you use a socket that is small enough so that it doesn't catch on the smaller lip. I didn't see it at first but when i couldn't get it to press out I found this was the cause. It's not easily seen if dirty, and also it's quite recessed so it's hard to see. I know there is a lip on the right side, not sure on the left side.

Fantastic thank you very much

Fantastic

jus subd.👌

Don't take up teaching !

Awesome thanks

Couldn’t of made it any clearer, first time I’ve tried this and it’s worked a treat 👍🏻

hi how did you get the software for pc? do you have the link where i can download it thx

Very helpful video .. I just did it today on my 540 SXS ! Thank you

Thanks man, really helpful

That’s what I was thinking of doing. I got a long bolt instead of threaded rod. Good video dude!!👍👍

Were you the bloke who stuffed it on the straight on to the grass?

Is it normal on the right side with (side with no washers) for the final barrel to have some side to side movement?

Good job Maddog 👏👏🏍

Which date and group?

Brilliant

Great tutorial, can You explain me directions of pushing in and out the bearings? Thanks Mate

Nice and consistent! 👍 Where did you place?

the other side does not have rings, no?. I bought the repair kit and only two come instead of four.. sorry for my english

Best one I've seen. Great explanations.

thanks for showing how everything sits inside. that was what I was most curious about before starting the job, i wanted to have a clear understanding of what needed to come out in what order. it was very helpful, thanks again. good tip on pointing out the ring too

if download indian marine chart or map? please reply me... my mail id: pandian.nano@gmail.com

Its worth warming up the swingarm with a blow torch so that it expands, the bearings will move with less force. It is also worth warming up the swingarm when fitting the new bearings because there less change of galling up the aluminium.

It was a while ago but think I started the bearing off by carefully taping them in with a rubber hammer. Then used the same socket method to press them fully in. Just be careful with the dust seals as they are extremely soft.

Thank you great video do you know how to put them back in for the new ones

very good idea and simple or easy extractor ...

Thanks for posting this video, I just tried this on my KX and it worked great!

Just a thought... if you put the big socket on he right (at 5:44) and the smaller on the left you can fit both the socket pushing and the bigger at once so you don't have to pull it apart to get the second one out.

Thanks for Info mate-no need to buy a special tool thati will hardly ever need ......your ideas use stuff most mechanically minded people may already have in their workshops

How come theres no sound?

Thanks, need to do my bearings on short notice and "morgan's tool" is both ridiculously expensive and won't make it here in time. This is perfect!

Thanks for posting!

Thanks maddog, very useful. To get around the 4Gb limit to copy over the entire UK, could you not just extract your external micro SD card from your smartphone, plug it into your pc, then copy the over direct, rather than going via your smartphone? Thanks, Frank

Great video, Thanks for posting this!