- 78
- 131 164
one arm works
United States
เข้าร่วมเมื่อ 18 เม.ย. 2014
I started my TH-cam channel because people were always asking me how I do stuff with one arm. this way I can show them. And to show people that even though I'm missing an arm I can still do a lot, even if it takes me 2 or even 3 times longer than someone with both arms. There are some times I find I can't do something, and need to have help.
KRYPTONITE leveling kit and lower ball joint installation on my 2013 Silverado 3500HD
#chevy #duramax #silverado #kryptonite #levelingkit
มุมมอง: 138
วีดีโอ
2013 Silverado cabin air filter kit
มุมมอง 1092 หลายเดือนก่อน
#chevy #silverado #duramax #diy #diesel #carfilter
MOVE bumper build.
มุมมอง 1943 หลายเดือนก่อน
In this video I build a MOVE classic rear bumper. #diesel #duramax #silverado #chevy #movebumper
2013 chevy 3500 door switch replacement
มุมมอง 904 หลายเดือนก่อน
#diesel #duramax #chevy #silverado #automobile #repair
2013 chevy Silverado 3500 Duramax fuel filter replacement
มุมมอง 3086 หลายเดือนก่อน
#automobile #duramax #chevy #duramaxdiesel #Silverado
2013 silverado SWTNVIN radio from Amazon turn signal, door chime sound
มุมมอง 2926 หลายเดือนก่อน
2013 silverado SWTNVIN radio from Amazon turn signal, door chime sound
mk4 golf front lower control arms, ball joints, tie rods, sway bar links, and wheel bearing.
มุมมอง 1066 หลายเดือนก่อน
Replacing my mk4 golf front lower control arms, ball joints, tie rods, sway bar links, and wheel bearing.
Adding a new winch mount on my trailer.
มุมมอง 1447 หลายเดือนก่อน
I add a mounting point on my winch mount and a 2" receiver mount on my trailer. #carhauler #trailer #winch
Climbing through my attic to run a new wire, with one arm.
มุมมอง 177 หลายเดือนก่อน
#attic #amputee #wiring
mk4 tdi golf fuel temperature sensor replacement. 16567 Fault code
มุมมอง 6038 หลายเดือนก่อน
#vw #volkswagen #golf #mk4 #diesel
2013 Chevy malibu EVAP purge valve replacement. P0449 Fault Code
มุมมอง 2.8K9 หลายเดือนก่อน
#chevy #malibu #evap #p0449
Replacing the upper oil dipstick tube on my mk4 tdi golf
มุมมอง 2869 หลายเดือนก่อน
#volkswagen #vw #golf #repair #tdi
How to replace trunk/hatch/hood etc strut lift supports
มุมมอง 319 หลายเดือนก่อน
#vw #golf #replace #strut #fix
Volkswagen MK4 golf brake light switch replacement.
มุมมอง 1.4K10 หลายเดือนก่อน
Volkswagen MK4 golf brake light switch replacement.
Replacing a Volkswagen mk4 TDI golf thermostat. 16512 fault code
มุมมอง 8310 หลายเดือนก่อน
Replacing a Volkswagen mk4 TDI golf thermostat. 16512 fault code
Western snow plow wire harness install. 2013 chevy Silverado 3500
มุมมอง 80410 หลายเดือนก่อน
Western snow plow wire harness install. 2013 chevy Silverado 3500
2013 Silverado 3500 wester snow plow mount installation
มุมมอง 14210 หลายเดือนก่อน
2013 Silverado 3500 wester snow plow mount installation
I tried SYLVANIA headlight restoration kit on my 2006 VW Golf
มุมมอง 6511 หลายเดือนก่อน
I tried SYLVANIA headlight restoration kit on my 2006 VW Golf
I put LED taillight bulbs in my 2006 golf, to compare how bright they are to regular bulbs.
มุมมอง 4211 หลายเดือนก่อน
I put LED taillight bulbs in my 2006 golf, to compare how bright they are to regular bulbs.
2003 s10 4.3L V6 thermostat replacement.
มุมมอง 2.9K11 หลายเดือนก่อน
2003 s10 4.3L V6 thermostat replacement.
2013 Chevy Silverado headlight bulb replacement.
มุมมอง 974ปีที่แล้ว
2013 Chevy Silverado headlight bulb replacement.
2013 Chevy Silverado brake rotors, pads, caliper replacement
มุมมอง 117ปีที่แล้ว
2013 Chevy Silverado brake rotors, pads, caliper replacement
I installed a plug for my block heater in my bumper. on my 2013 Silverado
มุมมอง 71ปีที่แล้ว
I installed a plug for my block heater in my bumper. on my 2013 Silverado
Replacing transmission filters on a 2013 duramax
มุมมอง 71ปีที่แล้ว
Replacing transmission filters on a 2013 duramax
I sand blasted, primed, and coated my bumper with HERCULINER.
มุมมอง 31ปีที่แล้ว
I sand blasted, primed, and coated my bumper with HERCULINER.
I installed LED fog lights on my MOVE bumper, using factory style plugs from amazon.
มุมมอง 50ปีที่แล้ว
I installed LED fog lights on my MOVE bumper, using factory style plugs from amazon.
Installing a move bumper on my 2013 chevy Silverado 3500
มุมมอง 156ปีที่แล้ว
Installing a move bumper on my 2013 chevy Silverado 3500
Me and my buddy having a harder time with four hands? Great job thanks
Was caught off guard by all of the diferent wires when I opened the box, this video helped me figure it out quickly, thanks for the help!!
Wrong title and wrong part. Vent solenoid and purge valve 2 different components.
Working with one hand totally sucks, I should know I lost my whole right side due to a stroke and I'm still work on restoring cars. I hit a deer in my dad's Buick Enclave and was looking for how to take off a bumper when I came across your sight. At least you have puppies to help.
Life saver! Just bought one! Thank you :)
cool!!
I just did this myself. One thing I noticed after I cut out the plastic piece there was a lot of dust on the there. So I used an air compressor and a dryer bush to clean the area before I installed my cabin filter. Nice work 👍
Why remove the throttle cable bracket? I understand the bracket attached to the throttle body has to be moved.
@@jasona8964 just to make a little extra room.
You have a problem with the backup camera? I installed mine and the display doesn’t come up when in reverse. Everything is wired correctly
@@aguilarc84 no I didn’t have any issues. I would make sure the trigger/power wire for reverse is hooked up.
@ appreciate the reply, I might have a bad head unit. I looked up the wiring, everything is correct.
Does that code mean the same for 2015 Malibu, I just to make sure I’m ordering the correct piece
I'm not sure if it's the same. I would assume if its the same body style and engine it would be
Wish the manufacturer would start making stuff that used to be easy to change yourself years ago . Easy again . Redonkaless
One of these days I'll get around to doing one. Nice to see how easy it is. A deburring tool works decent to clean up those plastic edges. Usually found in the plumbing dept.
Good job man incredible how much you do with only 1 arm. FYI GMupfitter or something has tons of wiring diagrams for lots of these trucks. Just gotta select it from the options to get the right one. Also if you didn't the liquid tape keeps longer if you store it upside down
Thank you for the straight forward approach. Appreciate it 🤙
Very creative. I like what you did from stuff laying around.
Nice.
Great job ❤😂
Me watching thinking this guy is left handed and then I realised. Nice job tho 😂
dis is a slick way mane
You should’ve dropped the engine first to make more room.
😂😂😂😂😂😂😂😂😂😂😂
Were there symptoms before the replacement? This is the most recent and thorough vid about the purge valve I can find!!! Good job. My 13 Malibu won’t go up hills or and cant seem to find power to pass people up on the road.
@@artieramirez8272 it just had the code, there weren’t any issues other than the engine light being on.
1:35 💥💥💥Think next time you need to remove something.
How is the camera holding up? A different brand I ordered only lasted 5 days.
@@samueldrizner4244 it still works great
Thanks!
What a pain to change a battery. Great video though thanks!
Did the grease last? Mine is also doing the same thing.. droped my light holder in the cavity just like you.. Been fishing for a while now just needed to take a break. Then i found this video.. I need that tool!!
@@jnewell1188 yes the grease worked good. Didn’t have any problems after that.
Are you gonna sell these?
@@ronwatkins5775 no. I just made it from stuff I had laying around in my garage.
Hey- wanted to say two things- first off thank you so much for the video- yours was the first one I found when searching for a solution due to my 2017 Sierra not starting and needing to replace the battery. Secondly, I am blown away that you can do all this with one arm. At first i had not seen the title of your channel, so didnt realize until about halfway through that was the case. I was like, why is this guy using only one arm LOL! I was having just a hell of a time getting the new battery in ( turns out the new one was slightly bigger/longer) and that of course is with two fully working arms! ;-) I have two nephews who have no arms, and so I see every day how people with disabilities are able to overcome them. Just incredible you can do this work better than i can! Thank you sir!
Who's idea was it to put a damn bus bar on top
wait ... I thought that was the purge valve ?
@@JamesMLaRose you are correct that is the purge valve.
The p0449 fault code is evap vent solenoid malfunction.
@@onearmworks I thought the evap vent solenoid was above the gas tank or above the canister. I guess i thought wrong
@@JamesMLaRose No you thought right. Vent is near the tank and purge is near the engine. This guys an idiot.
Youre tires are wrong way around they have a rotating direction
Thanks man, I appreciate it!
You’re welcome.
Great job making it look easy with one hand
Looking at possibly getting one of these for my 2008 Impala. Does it affect how the turn signal sounds? And how's the audio quality compared to stock?
Yes it affects the turn signal sound and the seat belt/head light warning sounds. I did notice any difference in audio quality.
@@onearmworks gotcha. Is it possible to record a video of the turn signal sound? I haven't been able to find a video of it no matter where I look
Yes. I will do it later tonight
@@onearmworks sounds good, thank you!
@@the_maximaal I got the video of the sound loaded now
Gasta en energia mas de lo que valen las latas😂
Have the very same motor in my S10 and needed a 'refresher' course. Tks! Great job!
Hay every time you add a 90 deg to any pipe you decrease the flow by 24 percent! 🤬
Good idea, thx.
no need to drain all the coolant first? my check engine light just came on due to the thermostat, think its stuck open dashboard gage does not move.
I don’t drain the coolant. I Just put a catch container under it.
No. The small loss of antifreeze is minimal. Only thing I'd add is make sure the thermostat housing/area is fully cleaned before reattaching.
Selten so ein schlechtes Video gesehen 😮
Where did you plug the transmitter in?
Where did you plug the transmitter in?
I had a receptacle on the other wall that I ran an extension cord from.
Thanks for this video. I have the same issue with my 2008. What brand liquid gasket did you use? Thanks
I used permatex ultra black gasket maker
@@onearmworks thank you very much. Has it held up well?
@@trentgilliam5192 yes, I haven’t had a problem with it again.
Nice work ,i need one now lol ,hugs from MN
Thats awesome. I actually just finished making a can crusher out of a spare garage door motor I had laying around, yours is so much quieter.
You are so strong man , keep going🤍
Just bought a suburban and the previous owner had this installed. Bluetooth is not working
I found if it’s connected to Apple car play. It can’t connect to Bluetooth.
@@onearmworks It’s not the SWTNVIN model, it just says Car Navigation on the loading screen so it may not be the same model radio
Does your music stop when you put thr truck in reverse?
No, it keeps playing.
Its in settings . I just cannot figure out how to change it from military time.
You saved me from purchasing this. Thanks.
Why?
Does this unit supports android auto or carplay?
Yes it does.
This is amazing