วีดีโอ

@@kc8wvg you are welcome. Good luck.

YW. No, it is a 5,000 BTU window unit.. not 15,000.

@@josedisco My understanding is that the Japanese versions are locked down in software and cannot be "opened up" for extended frequencies at all. Just the US and European version are capable. I only have first hand experience with the US models in any case.

Is the microphone on and adjusted properly?

@@Bob-s4j7x I don't have an AUX input at this time, so Bluetooth was the only way for me to get the audio to me truck's audio system. I'll need to pull my dash apart to figure out why the Aux is not working. It may have come disconnected.

It weighed 2900lbs before mod and approximately 4200 lbs after. Fully loaded with water, motorcycle and etc. is 6400 lbs. Pulled with an F150, but now have and F250.

@@donsdoityourself2547 Thank you very much.

@@JJ-el8li yes, sorry. Somehow the Volume increased during rendering. It sounds louder on TH-cam than it does in the Video Editor.

I typically use 10-15 watts given the high duty cycle. I don't run the full 20w except for some DX opportunities. I just have to be aware the finals can get hot, so I limit that activity. Once I get a cooling fan (ordered a small muffin fan) on the shelf with the radio, it will be less of an issue.

Could you share your setting on your computer & wsjt-x? Especially the Audio & Microphone?

@@BrianRamseysg01 I haven't used this for transmission yet. Don't really see the need for that. But, make sure you "Mute RX audio on TX".

@@donsdoityourself2547 Yeah I get all that no worries lots other things to do I do have quanshengs controled via pc different thing altogether. Thanks for reply

@@gregpearson7013 I works great. The SWR sweep makes it really easy. I am going to do a 2 minute video on how to use the MFJ-1925 with the G90 and ATAS-120A.

Pretty much, it's just what Don does.

Thanks. It is cool. I can talk all over North and South America and as far as Eastern Europe with 20 watts from my truck given good conditions. A nice to have when I am off grid in the CTC.

Amazon SUNNAREPOON Tinned Copper Wire... www.amazon.com/dp/B0CP7Q7LHF?ref=ppx_pop_mob_ap_share

Keith, message me on TNTTT and I'll give you my email address.

Thanks. Good luck with yours.

It will open both VHF and UHF assuming you have the US version. If you have the Japanese version, it will not work. Note, you will void warranty and just because you can transmit outside HAM bands, doesn't mean you should or that the radio will have output optimized on those frequencies. I did mine mainly to have access to GRMS (UHF) frequencies in case of emergency.

@@lawrencedavidson6195 thank you.

😂😂

@@stevejolley5651 Hi.. good question. Actually, it does. Both the inverter and solar charger are noisy as well as the LED lighting. If I want it RFI quiet, I shut all that off. The inverter is the worst, so I usually just turn if off when I am on the HF. The solar charger is quiet at night and the LEDs are not really that bad, but easy to turn off.

Both OH8STN, QRP, and K8MRD have briefly touched on the subject, but not explored it in depth. I have a theory that the 120v ac to 12v converter creates RFI. If all 12v, no problem. Genasun, allegedly, makes some quiet controllers. I am Considering a 24v 300Ah system to start. Thank you for your time. Great job on your build!

😂... Thanks. It's the Matrix. 😉

Thanks McDave! Enjoy Sturgis. I won't be able to make it. My wife had some major surgery for her cancer two weeks ago and we are still nursing her back to health. Next year hopefully I can make it . Life just got in the way the last two years. In any case, no dongle on the BougeRV.. but my new tablet has one! 😂 Stay safe. Always good to hear from you.

The walls are 1 inch thick, so 1x1 or 1x2 inch Square steel tubing welded would do it. You can decide on hinges and spacing of "studs" depending on the weight you expect to carry and may need to strengthen wall beneath with a good header.

Will do! Many thanks. This unit can be a freezer too. Cools down really fast.

Absolutely not. 1500w at 13.3v would draw 112 amps. First issue is that it only has a 30A BMS, second, it does not put out 110VAC, just 13.3v. Lastly, even if it could supply the 112A and the inverter had no losses, it would only run for a little over 3.5 hours before the battery would be flat. If you need a 1500w heater for off grid, I'd recommend a cheap diesel furnace. Very effective and efficient. Using electricity to generate heat is never efficient.

I like the idea of the light. I use my phone's a lot. There are some good videos on building LiFeP04 batteries, but the BMS has to match the battery capacity and you need to choose based on number of cells (I usually build with 4) and max current you need from the battery. After that, then you need to consider if you want a basic BMS with no interface, or a Smart BMS where you can program and monitor. The BMS that I use (Daly) is a good brand and I like them..the have all the parameters programmable along with thermocouple for temperature monitoring. You can figure it out. Let me know if you have any questions.

@@donsdoityourself2547 thank you sir. I may take you up on that!

Thank you kindly. Good to hear from you. I hope all is well.

Yes it is. Used it for 4 weeks on a trip in June/July and all worked well.

Yes, it will drain from bottom tray and I have a vinyl tube that goes through the inside of the cabinet and then through the floor to drain on the ground. It works well.

I have one in my grooming trailer and Il be at a house use air, go to leave, and it runs out the sides, even with a tube I have attached.

@@reej2023 try shimming the front of the air conditioner so it slants back some when the trailer is level. Notice how they sit in a window. You are not draining completely. That is what I had to do with mine to drain properly.

@@williammcgill1562 there is a vinyl hose connected to the drain that goes down the inside of the cabinet and through the floor. It drips on the ground.

Sounds cool!

You are welcome. So happy this was useful for you.

Approximately $12k

@@donsdoityourself2547 ok thank you. My Wife and I just bought one that a guy converted last year and never used due to health reasons. Ours is a 12' single axle V nose Forest River with household fixtures and an on demand hot water heater with slide out a.c. tv and all other sorts of cool stuff. We bought it for $10,500 and just had it inspected by the fire Marshal and all is good. I still can't believe we got this deal. Thank you for your video. These are made so much better than a traditional store bought camper and this is our first. We're super freaking happy with it and I'll be camping in it tonight for the first time. Woo Hoo!!! 🙌

@@Spinnaker617 wow.. that sounds good. Hope you have a great trip. This is my 3rd build and they usually cost about 2 times what the basic empty cargo trailer costs. I added quite a few options with heavier axle and etc. and spent some extra money on the solar power and amenities, but at the end of the day, you end up with heavy duty build. Best wishes!

@@donsdoityourself2547 Thanks man!

@@sadiegirlwolf Greg, I ordered it off Amazon. You should be able to find one there. Search for a Lippert Single RV step. You should see one there for about $77.00.

Thank you very much will do!

I know it goes as far as the top of the GRMS channels (467 MHZ). Never tested it past that.

Thank you! Appreciate the feedback.

Out West I used a 1 Gallon Giant Loop Armadillo Bag. There are places where if you get turned around and backtrack, you might need it. Whenever I used it, I would dump it on as soon as I could and roll it back up. It was peace of mind to have it. A few times in Utah, we had to backtrack and find other ways due to downed trees. Came real close.

Thank you. Glad I had it this summer. Spent 3 weeks in 90 to 104 degree temps in Nebraska during Late June/July. It was a life saver! 73's.

Glad to hear your shoulder is doing well enough for you to work on your CTC. When you get into it, if you have any questions and I can help, feel free to ask. Actually, I may be in Nebraska in June to see my son and grandkids. My son lives about 2.5 hours southwest of Omaha. Will know next week if I can go.. I will be traveling with my 6*12 if I go. CWS will be going on while I am there for sure. I plan to take my grandsons camping and do some fishing. Just going to hangout. No projects on my son's house planned this year.

You are going to be really close to us. We're right by Offutt AFB.

Thank you.

Thanks

Sure thing! Turned the end screen off.

Thank you very much!.

Thanks. Good luck with your build!

It will hit if I don't raise it high enough , but I put a roller on the door so it does not snag and there is no harm if it does hit.

Glad to hear that!

Hi. I am assuming everything else still works okay.. just no expanded transmit frequency range. Correct?

Evet doğru

Gmrs frekanslar da tx yok

144-146 ve 440-440 var Ben VHF136-174 UHF 400-480 yapmak istiyorum ilginiz için teşekkür ederim

I did some research and it appears the Japanese models will not work this way. Was the hardware the same? See old post I copied from a Facebook user group: *******" You can do the MARS mod as described but it will not open the frequencies to match the US band plan nor up the power output. About the only thing I would use the JA models for is a Wires-X donor radio if I wasn't concerned about the max power output and don't mind only using 1/3 of the band plan we have.

Many thanks!

It is manual.

@@donsdoityourself2547 gotcha!

Not sure why it wouldn't. Does your radio have different firmware? Works on my FTM-200 perfectly, but it is a US model.

Ftm 200d direnç yok ne olabilir lütfen yardım edin teşekkür ederim