วีดีโอ

Do you think it would be possible to do thermostat without taking the steering pump off

You guys😂😂😂 crack me up but very good.thank you.

You didn't need to remove the rocker cover and lock the camshaft then? Did it time up alright just from your markings?

I have the same noise, does this also cause the gearbox to whine while driving?

Hi. Did you put the check valve the other way around?

A new cs comes with a locking pin, to stop it from moving out of position. Did your 2nd hand one come with locking pin? And did you have any issues after replacing thr cr no that it has gone months since uploaded. I need to remove my cr to get behind it and replace the cruise control stolck i think.

Just working through this on my 2005 T5 174 axe...... What a nightmare started to go into limp a couple of months ago... Going into limp on long hills in high gears, was like it didn't like holding the boost for too long, around town you could drive it hard, but motorways or medium to long inclines it'd go into limp, could always restart instantly though Had it diagnosed in a garage id used for years, they tested the n75, the vacuum lines, the boost sensor/map sensor, to no availand finally said it has to be the turbo..... It wasn't ffs, they then said they found a small hole in the intercooler but didn't think that'd cause it so we parted ways 😡....2nd garage... Vw specialist, changed the intercooler and boost sensor but no fix🙄.... Checked all the usual stuff couldn't find anything, we then used it on the nc 500 for 2 weeks😱, just got back, 2000 mls, must of had 50 limp modes...... Just tried to not go over 2k on long drags and just got down into 4th or 5th and just on/off the throttle to keep it just under limp activation 😩, going in again next week for another go at it, garage saying could be an ecu fault 🤔🤔🤷🏻‍♂️......... Can n75s give intermittent faults, as during this saga it first had overboost.... Then apparently underboost.... Latest before we used it for Scotland (no way i was letting my wife down, she'd worked to hard planning n booking multiple campsites) it was showing "boost value deviation"...... Just hope we can fix it, we've owned it 13 years now and put a very expensive pop top roof in it over last Christmas.... Any advice or pointers,, pleeeeeease shout out 🙏🏻🙏🏻🙏🏻, cheers if you read all that 👍🏻

Have you done this with a T4 sliding door lock barrel? I can't figure out how to get the roll pin out. Any advice will be great!

I have heard bad things about swapping out the dmf for a solid one, how have you found it? Great video, well done.

Дякую за допомогу ) 🇺🇦

I just got a mint 2004 2.5l in Merlot red. 76,000.

How much was the back box. Where did you find it . Keep up the good work mate

I saw your t5 alternator change, i wonder is power steering also on the same belt and how hard would that job be, thanks man

How long did this last? Gonna do the same to mine as ive already replaced the ignition switch last year and its starting to play up again. Any issues at all with this kit as ive bought the exact one to fit into mine. Many thanks. Love the video very helpfull

7 minute install, from the time I opened the car door to begin until I closed the door to walk back to the tool bench and put my tools away. A great deal of that time savings was down to your tip about a curved pick tool. I used my stainless steel dental picks and the vent came out in seconds. It was all plug and play, connection was easy, and whilst the sound is not the best, it gets the job done. Thank you.

Hi, what model of engine do you have, how many horsepower?

Thanks

Never finished this?

The oil in the intake is from the pcv that comes from the tappet cover and goes to the air intake near the air filter. These engines drown in oil unless an oil catch can is fitted. Your egr looked like it was inoperative. Should be a shiny bit on the shaft in there. Also that is not a throttle body but a shutoff valve. Fueling is all done by the injection

How long did it take you

Thanks Alf is there part two mate?

Did you replace the intercooler pipe after? I’ve bought 2 new sensors, and also noticed my intercooler pipe wasn’t sat right,,mine seems okay now though. I have noticed the wiring on the air intake map sensor has 3 pins but my sensor itself has 4pins, not sure why. I have done loads to try and get rid of this underboost I’m hoping the sensors work as I’ve only just bought the van and haven’t been able to drive it properly lol. It goes good somedays then go back into limp. I’ve done vacuum tests, changed bits and pieces, & still nothing. I did change the one map sensor for a second have one I had but not sure that’s faulty too lol

Did it work after! I’m having exactly the same issues on my 2.0 transporter. Done loads of the tricks and cleaning next job is egr off

The black one is for left hand drive. The white one is for right hand drive. I don’t know what the difference is but it possibly rotates in the opposite direction

Thanks for the video. Legend mate

EGR DELITE

Thank you for video

Is it possible to remove the oil carter from underneath just by loosening the bolts only? I have once removed the engine to change clutch and flywheel and so forth, but never considered removing the carter pan to clean it out after an oil flush.

Helped me a lot mate cheers

Good video and details 👍 I’ve also got a Crafter 11 plate 2.5 runs great’ but as always been smoky when accelerating or idling in traffic’ and only black smoke 💨? Loads of people have looked at it’ but no answers. ? Any ideas 💡 👍

When you hade problems . was the engine hard to get started ? TAKES 3-4 sek to start running..

How far can these two get?

did you find the oil leak around the cooler/filter housing? I have the same all covered in oil not sure weather to replace the lot or just gaskets

The flappy bit is the throttle body. With an EGR system a diesel needs a throttle body to limit the amout of air coming in through the intake to offset the exhaust gases coming from the EGR system. The more the EGR opens the more the throttle will close, it's also used as a safety shutoff.

Do a EGR delete and it won't get clogged up again after cleaning. Most of the VAG engines seem to suffer from this EGR issue with clogging up.

How much tork for crank shaft ? Sorry I’m French

Wow what a video, every step in detail not skipping a thing just how it should be thanks for this video ma drilla

Just rev the fucker to the redline and it clears itself

I do mine on the motorway mate whilst driving to my destination. It works great!

No mate…. Just no

Really piliz

Hello boss I need Crafter vineDeshsl inzaan Srarap price in Doha Qatar piliz u Give me Yeddarsh piliz

'Promosm'

Where did you connect the black earth wire to?

How did you take the fan off mate

KFC time

The only thing I can say is that I've notice is ac fans are more power full. My van is it's 3rd fan. Poor bearing design made to fail purposely.

anyone know, does parking sensors work without original radio in E85?

Y'know what, these VW Transporters have one helluva lot of problems, why do they have such a fan base? I skipped through this, didn't find if you fixed it or not.

Was using a rivet like u