วีดีโอ

Best Way ty i use an old bilge pump and pump to a spare can as I use vinegar and dawn and hate to waste the water pumps quickly will reuse twice or so........

One flaw is supplying the new water from the bottom. The weight of the water in the trash can is going to try to backfeed into the drinking water system. Need to supply fill water at top with air-gap between supply water and weir. A small amount of water can be drained from the bottom at the same rate as the make-up water. Also maybe remove the prop during this operation. Or cross your fingers with muffs. In any case, there's really no reason to run the motor for more than a few minutes to conduct tests or flush cooling system. Just my observation.

Do you think that’ll work for a Yamaha 115? My water pressure at home is only 35 psi

Hey there. Did you need up doing an instant video? I have the same unit and wondering what setting you pic for the 3 in 1 transducer when you start the set up

Where is the installation video?

Can't do that with a hydrofoil on your engine... ask me how I know.

Went to the second hand (recycle) yard got a used clean drum about 44Gal/170L for $10, cut the top 1/3 off with the disc grinder, there is no need to put the motor in gear so hung the garden hose over the side, run the F70 for 10 minutes. When finished take the hose off the faucet and drain (syphon) drum water into the garden or the storm water pit.

I ended up buying Rydlyme descaler and a small pump to flush out my old Yamaha 60hp 2 stroke outboard. I dropped the lower unit of the engine, and hooked the output of the pump to the water intake tube of the engine. I also had to take the thermostate out, but it needed replaced anyway. You mix the Rydlyme in a 5 gal bucket with 1 gallon of water, and put the pump in the bucket. The water comes out of the pee valve into the bucket, and is then run back through the system by the pump. I ran it this was for a few hours. There was at least 1/2" of sludge on the bottom of the bucket when I was done. I could not believe how much crap came out of the engine. It is a little pricey to do it this way, but it works.

Great informative video...did you use any chemicals to flush the outboard motor...?

What size motor is in the video? need to do this on a 115 2 stroke. So tired of ears,

My dad and I flushed our engines with muffs and never had salt problems. The bucket will not do anything that muffs can't do as long as you're using the muffs properly.

Darn good idea my friend. I may try this on my Yamaha 50 / 4 stroke. Just gonna have to measure the lower unit and bucket. Steve

Was wondering if you added vinegar to the water to flush out salt buildup?

You got my like with the "Come on man" comment lmao

Where did you find the fittings

love it thanks

Not only does this flush your engine better, if you are tuning up your engine on mouse ears, you might find out that when you take your boat to the ramp and fire it up in the water, it won't run the same. You need to run your engine lower unit under water to get that back pressure on the thru hub exhaust.

I’ve been looking for a large trashcan or some thing like a barrel to run my Yamaha F150 outboard and it needs about 26 inches from the front fin to the back and most of the garbage cans I find around 24 inches. Any advice appreciated. Thanks.

I cant find that fitting anywhere... what store did you go to? Also cant find the rubber gaskets for males only females

This will work great for my little 15hp suzuki!! Thanks for sharing

Did you ever make the installation video? I'd be very interested to see how it turned out.

What are the snook locations in Tampa??

Fun to watch. What leader did you have with the 20lb braid? Surprised you were able to get them off the bottom! Nice job!

how long you flush the outboard?

I’m picking up a used boat next week and started watching these video on flushing. I like your video but disagree with running the cool water thru the flushing process. I think the motor won’t get to temperature properly and the thermostats won’t open so water won’t properly flow thru the motor. The motor has to heat that water up so thermostats open otherwise water stuck on other side of thermostat doesn’t go anywhere, no? The bucket way is the way to go though because muffs create the same issue by constantly introducing cool water so it’s not a proper flush.

What about a drain on the bottom instead. Then fill the can as usual ? Not sure but I've tried it with muffs and the can with no drain . Only problem is getting the motor to lift out and tipping the can over . Heavy . Do you put detergent in the can when you flush? I'm in brackish to salt water Thanks . Mercury 30hp

What's the lengths on those rods? Thanks

What is a good rod to pair with this reel?

Hello, good video. I want to add one to my boat but I'm not sure if I have space for the GO7. Can you share how is setup? I have a 2018 Sea Ray 19spx

👍🏽😎👍🏽

2/10 rating. 40 miles and you caught small fish????????

What camera do you use to drop down?

This reel was built to throw lures at big species . Bait wise works for larger species but The slammer lll has a 1 lb minimal drag verses wide open adjustment. Top plate also has a hydrophobic coating so anglers doing home servicing should not grease or it damages the hydrophobic coating. The second generations of Slammer lll also came with a better bail assembly. A few of the original Slammer lll released in 2016 had a bail defect and Penn offers a upgrade to correct this. The second run of Penn Slammer lll come with the better bail. #2 generation has a letter on the inside of the rotor that indicates its the second edition. Most the slammer lll sold are the upgrade version 2 but stores holding old stock may still have the originals.

dumped water on you? Be glad it was water...

Did you have autobail problems ,wanna buy 3500 for pike fishing with lures? Bail seems to close on casting?

Nice mangroves.

How big is your boat ma? I have a 21 footer

What town? Tampa pretty much every bridge has a no fishing sign. And no parking sign. And they put up tall rails that makes it difficult to reach over.

What would you go with penn spinfisher 4500 or penn slammer 4500? Is the $100 price different worth it? Thank you!!!

Sweet video! I’ve been looking for an easy way to flush!

Lesson for the year--flip that hat the correct position--the shade it will give your face is about 10X what those shades will give you AND maybe keep you from having (like me) about five and counting skin cancers cut off your face. The baseball catcher look, doesn't look smart on the water.

Hi! I have a Majorcraft Solpara 1002h 60-100g. Would you suggest me size 4500 or 5500 for shore jigging with Penn Slammer ?

You got grouper slapped...lol. Enjoyed the video. Keep producing.

Big sheep's at that bridge for sure!!

Nothing like like getting offshore!

INice job! Subbed!..

keep goin yall make some good videos funny to keep grindin

We fish the same waters. I've had a go7 with active imaging for 2yrs now. You're going to love it. Every time I go out (west of egmont ;) ) I'm finding new legdes clear as day. In the bay too. Subbed

We went out 40 miles Friday and delt with the same slowness! 26" red snapper, some Bonita and a bunch of bigger lanes. It's tough out there man I'm learning with you!

I'd love to get up with yall and fish one day. I just moved to the DTSP area and have a similar vessel set up but no knowledge of this water! Regarding the camera angles, I usually like a mix but prefer the overviews of the deck/personnel. I know what a reel looks like when it's spinning lol... Tight lines