วีดีโอ

Thanks for the video, I was able to remove the bad wheel, then run it across the table like I was pushing a toy car as fast as I can which dislodged whatever was slowing the wheel down. Reinstalled and the vac goes in a straight line.

Thank you!

Frank, it is not the main wheels but the front single wheel.

It is not the main wheels, it is the front steering wheel.

A good kick seems to sort mine out for a few minutes. I have stripped it down. replaced both drive wheels, cleaned sensors. Cleaned IR windows ,checked bump switches. Still requires a kick every now and then. I think it must be a bad solder joint somewhere. Will check further if kicking it stops working.

Thanks so much! I actually had the "tire" (rubber surround) from the wheel fall off and it was necessary to remove the wheel to get it back on. Couldn't have done it without your video!

Video also works for Yeedi k7000! thank you so much

echovacs?

I took out all the screws and it is still stuck and won't come out. My deebot says wheel issue

I was able to change the leg of my deebot with your video.. thanks a lot mate 😊

Thanks for such a great video. I am having an issue where my T8 goes in circles (right motor not functioning properly) I watched your video and removed the right wheel. I didn't see any burn marks or anything on motor so I attached a 18650 battery with leads to the motor and the motor and wheel were functioning. There was no debris stuck that would affect the rotation. I put it back together and same issue. Any ideas what could be going on? I just tried covering the drop sensors and turning the vacuum upside down and turning it on. Both motors work. The right one feels stronger than right.

thanks man, this really helped 🙌

What about the right side? It’s built differently and the wheel does not come out the same way. This was only 50% helpful which is still an F

thank youso much for the good guidance sr..

All i did was change the main brush motor assembly and now deebot refuses to dock, i've been into it enough to do it in the dark and he still does the exact same thing, turns toward the dock, goes straight then to the left - straight - left and so on then when he nears it he's off to the right and can not find his way onto it. That was with 2 different docking stations. I ordered a new machine. Forgot to add , in the 3-4 years i've had this there's never been any problems with it.

is that drive by itself not very good? or were you just upgrading to a bigger one? nice video! I bought this ssd off ebay for 20 bucks worried it may be junk, 128gb

I'm thinking about doing this as well. Do i have to re-install windows or buy windows? What is the next step after installation?

is this x1 carbon first gen ?