วีดีโอ

Is viano air suspension comfortable for rear passenger?

Just havk the wii. Put all games on an external drive and you don't even need a drive. Ssd is instant with almost no seel time.

So well explained, thank you!

My wife’s 500 center right vent was dislodged, couldn’t move it left/ right. Up/ down worked fine. Looked at your video and it looked far too complicated so I just used the car key, directed the vent “down”, left and put the key on the flaps and pushed them towards each other. Clicked to place in a few tries. Under two minutes of work

Hi , thank you for a very informative video. Would this fault cause cold air not blow out? I have just topped up my ac gas and it’s not getting ice cold . My fan only works on 5 .

I found your video very interesting and would be great full if you could assist me with info. re- the in's and out's , does and don'ts of the move & if possuble a conversation via whatsapp.?

Hi Fixitfallows good video can I ask a couple of questions are you one of Londons Finest the London Green badge driver and thoughts on the LEVC TXE pros and cons yours is low miles 67k are you on original ERAD did you get extra extended warranty do you use the range extender more so these days save mode or smart which home charger do u recormmend or do you just find a rapid charger when your out at work also I know xc90 is same but Volvo steering v60 will that model fit the Levc cab thanks in advance for reply I gave u a thumbs up be Lucky

Yes .... hmmmmm...quality 😂🎉🎉

The open camera app does not work. So what do I do?

Seems like surgery.) Thanks for video i looked for this job.

Hi is the large one the same size as the larger one??

I can't find the default recorder on my Samsung A13

great video mate- when i did it it took ages to get the clip out and when trying to pull the pipe out of the slave, its stuck fast!! Looks like a few blasts of wd40 needed but if not, may have to install the new pipe then cut the connector and rejoin where it meets the master pipe!

I just took the mauve seal off and it worked 😊

Is this the same blower which sends air to the middle and back seating rows?

Thanks again. Looks like I'm following in your footsteps! (last 'thanks' was from one of my other accounts)

Thanks so much, very informative

Thank you!

Very helpful, you could come at Heathrow feeder park and there will be plenty of work for you.

How did you separate the two tubes?

Do you have the link to the AliExpress piston parts?

Thank you did mine today, my heater was blown. Might be summer but can still get cold at night ❄️

Hi there. I've just successfully replaced the aerial base (and antenna) on our 2012 Fiat 500 and thanks to your video the job was an absolute breeze. Thank you.

Just bought a 2017 Countryman; love the car but hated it (a bit) today in slow traffic. Going to check if it is also missing that spring and also hoping it is! Because then I can fix it!🙏 I’ll update here if it is!

Hi, how did you reattach the base to the car, do you remove the sliver bolt and cage beforehand and then pop the base on the car and tighten up from below? If so it's a little fiddly, there is also a black plastic clip which keeps falling off when I go to do this.

Where do I get those break pads? They keep giving me the wrong ones.

Thank you for the detailed video. I felt like I was going to break my door.

£20 quid is better than £35 pound a panel that is priced up today’s prices good job.

Hi did you get the top zip ties off too? Was it easy to fit. Looks tricky!

Hi, what year is this fiat 500 please? I need to replace my base and aerial also. Ours is a 2012 model, looks like the same aerial and base i think. I see some of the later models have slightly different aerials.

Thanks. Exactly what I needed.

Hi, thanks for the video! my neices car has the same noise coming from the slave cylinder, also after driving for a while the clutch becomes sticky around an inch from the floor, would the slave cylinder also cause that to happen?

Just trying to get the spring in location. Looks like you have to push down the clutch to make room. And I’m still struggling Do you insert the top or bottom end first.? The vid doesn’t show it. Thanks.

How did you know to bypass the thermostatic fuse? My fan was squealing and now only works on full power so it seems like maybe it got too hot and broke the thermostatic valve? Theoretically if I just fix the squealing and then bypass the fuse it should be good to go right?

Great video, well explained and demonstrated….

Please can you point me to the spring needed? Many thanks.

If I put my hand near this fan though the air is coming out at me. Where is the intake for the rear AC?

Thank you so much for posting about this. It solved my problem!!!

I tried some AliExpress TPU tubes - Baent brand. 3 out of 4 have punctured. Admittedly, my tyres are fairly thin and lightweight. But I rode a lot of miles with butyl tubes and gad no issues. I'm going to keep 2 TPUs in my saddle pack as spares. But I'll stick to butyl for regular rides. Cheers

how do you get them off in the first place? HELP!

Garbage,ride now only job

thanks for video my car needs changing to

This is brilliant - Thanks so much. It’s night and day better than before. Fitted the part linked from Stevenage BMW to a 3 door F56 Mini Cooper with a heavy clutch. Massive improvement. Why it’s not like that from the factory is a mystery!

Thanks very helpful 👍

Hello Craig! Shel all the way from Singapore here. I bought that exact mic last year, thought was spoilt and bought a second one with the same problem.... static. Then thought it was my nokia not being compatible! Today I decided to go back to the problem, determined to find a solution online and found this video of yours. The Open Camera ap works greats!! Damn - wish I had found you earlier. Thanks so much! (Saw your updated video but my phone doesn't have the advanced settings for audio).

Thanks , has to be the best video I have seen to describe this job, cheers

Thanks did this to my A4 last year and now needing to do it to my A5 so needed a refresher, hopefully it’s the same process. Only thing I noticed was I needed to open my break fluid cap when pushing the piston in and make sure it didn’t overflow. Then top up as you pump breaks again ever so slightly.

250/2= 125A

I I have a small place we're my fence panels gos I had to get someone to cut the normal fence panels in half to get it to fit is there only one would help to do this

Just wanted to say thank you for everything . God bless .