วีดีโอ

Hi , thank you HarrisSimpson.

Hi, yes, it is, as long you're using a springless seal .

@hostingteamchannel8124 ok cause I need to change my oil pump my light came on the other night cause of a bang in front so I stopped and park it no there is a noise in front and no oil pumping

Thanks for the support 🙏

Welcome ,Toku gamuchirai, Siyaliyamukela 🇿🇼 .

Hi , thank you for watching our content.

Hi,Mostly incorrect spaced of pistons rings. Incorrect clearance of piston ring gap.

Hi,as far as I can remember, p0011.

Intake camshaft too retarded ,sometimes Intake camshaft over advanced .

Hi, thank you for watching. Please try to clean your carburettor and reset your distributor using timing light if you have it.

Hi, thank you very much for watching our content. PTFE seals need more time to adapt to the shift . This type of seal is springless. The lip of this seal takes more time to contract in order to adapt to the shift .

@hostingteamchannel8124 Thanks. So if you use a seal with a spring in, no need to wait to start the engine?

The seal with spring no waiting time is required.

@@hostingteamchannel8124 Thank you

Hi, isai good clutch kit , reconditioning haaa mazuva ano havacha nyatso gona, uye vakuisa cheap material.

Nemi muno tendwa nekuti kurudzira ,maita basa nenguva yenyu yamatora.

Hi ,collapsed valve rockers, I recommend the genuine rockers to avoid loss.

​@@hostingteamchannel8124 where can we buy genuine ones?

Hi , CAPETOWN SA .

You are very far, I am in tembisa, I fitted the rockers for the the 3rd time yesterday in one month and still today the knocking sound has started again. I wish you were around.

These trucks are problem

Hi, Nhamo. Thank you for watching. Are you in SA CAPETOWN . You can contact us on the following phone numbers, 002761 8388 619,002784 413 5063 (BLESSING)

The oil check valve was bad , we installed the new one, and the condition of the vvt gear remained the same .

@hostingteamchannel8124 which valve is that one

One way valve , you can locate it in the engine block, remove the alternator for you to access that position .

​@@hostingteamchannel8124was it the yellow check valve? When you said that it remained the same the VVT do you mean that it fixed the problem or it remained retard

It was the faulty fuel pump ,we replaced it with the new one , the car is still driving perfectly no issues.

It's never too late. You can always bring it back to life. It's a great car.

Hi , yes it worked fine for me. But I recommend sensors from mazda dealers as well .

Hi , yes, you can get an aftermarket sensor . If you're in Western Cape Town, please try Korean Boys , they do new and second-hand sensors. Thank you very much for watching our content.

Hi, sorry, Brandon. I don't even know how I missed this question , I hope you get help .

36 or 38 links?

Hi, thank you for watching , OK.

Hi, Nissan QG16 .

Vacuum pump

I tapped it in with a small socket and hammer very gently.

@@hostingteamchannel8124 did you replace this for a oil issue to the camshafts?

@@hostingteamchannel8124 also removing it this way doesn’t get any debris into the engine?

Yes

125Nm

@@hostingteamchannel8124 thank you

Did you find out the culprit?

​​@@Brycefox haven't had time, just bought the fuel pump not long ago waiting on a friend to help me

Hi, thank for watching our content engine type is GWM 2.2L 4Y( Toyota 4y) it was fuel injection before then it was converted to carburetor . For gearbox type I am not sure.

Sorry about that, I am going to improve towards that issue .Thank you very much for opening up.