วีดีโอ

Amazing how you did relief cuts under those wet set brackets

Where would.i buy the brackets?

I would not trust dry set without sheathing the entire building. They do not offer enough uplift, shear or moment resistance compared to wet sets, perma columns, or the traditional post in the ground. That is what sets pole barns apart is that a bulk of your moment, shear and uplift strength comes from the fact that you typically have posts 4-6 ft in the ground. There are several reputable companies that have pulled away from using dry sets without sheathing which at that point you're basically a traditional stick frame house.

That is sexy way to do it for sure

Why are they better than just using a Simpson bracket?

Dont bother with hiring these ppl. I called 5 or 6 times over 3 months and NEVER heard back. Business must great to never bother calling back new customers.

I’m down in Texas and would like to know how to do that foundation. Do you put rebar in the holes you dig? Do you bell it out at the bottom?

thats the dream

I’m curious about the pier and pad foundation. My feels the slab can move everywhere except where the piers are. How do you keep the pad from cracking and breaking frost heave?

Monolithic slab?

What's insulation of choice?

Who spray foams the underside of a roof in 2023? Please comment because the guy makes no sense.

You spray foam a ceiling bubs. Very bad idea for only one reason which trumps all the good reasons to do it. Smh

Those are not wet-sets.

i had to find a place to comment about your fuel pump video lol.. pretty much every single thing you said in that video is wrong, your using fuckin marrets under the truck, the fuse panel is called a tipm hahaha not a tpems, etc etc etc.. no wonder you turned the comments off. and if u want to help someone, at least help them with correct info man lmfao!!!!!!

These are not “wet set”

Beautiful building, and it is insulated. I could get my truck in there, way to go. 👍👍👍. 10-3-2023

Please verify Side walls 14’ and center is 19’?

Do you have any trusses certified for those of us up north in the snow belt? Gotta hold 42lbs/sqft For a 50ft wide span, plus eve overhang...can always go on 8ft centers instead of 10ft...

Use 2x4 side boards? Isn't 2x6 boards better?

by using the peracolumn wet set on piers without a concrete slab added- is there anyway to get the skirt board low enough to eliminate the gap under the barn siding? could you set the columns a few inches below grade or would that be considered wood in the ground and defeat the purpose of the bracket system?

Could there be issues with frost when the ground freezes pushing on the slab since there is no full foundation wall and the fact the piers are tied to it and below the frost line? The piers are not going to move and the slab may with frost heave in the winter. Are there any issues with it cracking at corners and/or where the piers meet the slab? Thanks

Did you set the post in before or after you poured the concrete

This is a beautiful shop. Is there a way to be directed to where to find the trusses and supports as I'm in Utah? Thank you.

Did the spray foam stick to the tyveck? How did you keep the tyveck from melting?

Really nice job!

Do you guys work in California and how much did this building cost

Sweet!

Love the building hate the colors

Do you build in E Tennessee ??

I’m in GA, have a newly erected 30x50 tubular steel building, and they didn’t lap my siding past the concrete slab, so the bottom of my siding stops even with the concrete of my slab. I’m getting water inside my building in a couple of places where rain water is splashing back up and under my bottom steel floor rails. What is this trim piece called and can it be purchased at a Home Depot or Lowes, or where can I get it?

Looks amazing! Did you do all of the construction or was the interior of the house completed by a different contractor?

I need two 60x100 trusses

Curious to know what those trusses are called?

where in Kansas are you. I am near St. Marys KS weighing a metal metal or pole barn.

Love the video. Would you recommend these for an open pole barn? No walls per say. What’s the max height?

What do you do with the tires after cutting them just curious. Do you make something out them ?

How much?

Hello, What is the final cost of your building...? A break-diwn would be nice. Thank yiu for your Time, Greg

I have a 6" slab would that be sufficient for these brackets

So I have a question so are the steel post and trusses cheaper than laminated and what is the cost thank you

Could I use this on a 6" thick slab

How do you cut the corners so the fold right?

How do u do the corners where they meet?

show rat guard corners

I’d like that exact building for an airplane hanger and one for residential. I’m 1600 miles west of Kansas

By 50 does that mean you can 5 cars inside of it?

What's the wind load rating on this building?

Love the insulation. That is gonna be very cost efficient on Temps inside

This is the system of foundation I imagine. But can you build a house like this? I would like to build a pole-barn house.