วีดีโอ

Please respond and let me know if you found it is you for this if you found the result for this

Look me up on facebook, ill walk you through this. Im under CustomMultirotors and Rickamanda cox. Just send me a PM.

calibrate the esc with full charge 4S - 6S battery will do.

i have similar problem here , all calibrated, radio, esc, gyro, compass, seem all perfect buxhawk say all ok, i can am but motor not spin when i give gas. Pixhawk (i have a real one) really start to bother me .

I have the same problem. But in my case, It works only in calibration. Except cal. and motor test, motors never works ㅠ_ㅠ

Radio calibration?

I have the same problem ..!

Had very similar issue with also brand new pixhawk. However I had bad gyro message, failed accel and a crazy HUD moving around on mission planner. I tested by replacing this pixhawk by another one and problems were solved. I am sending back the faulty new board. I also had like you the same motors behavior ( speed increases without input and you can only bring the throttle down to cut them off)