วีดีโอ

Nice and Lovely, sir ....very informative

Can you explain why are you using OSPF as IGP, why not only iBGP. Is it possible to communicate R2 with R3 only with iBGP without any IGP ?

my question here would be if you have different AS and using EBGP you won't like to allow external AS to learn your OSPF table , In that case what could we do to route from R4 to R5 but R4 is not supposed to learn any networks inside AS but still able to ping R5

Good job.

Great video 👍

you have not explained, why you are doing so and so. By the way, how far you are now with the Data Center Expertise learning and working?

Why does in R3 and R2 , when you do show ip route , it displays the prefixes on R1 as "B" and not "O". Is the cause was that when you did not configure update-source loopback on bgp configuration at R1? Please enlighten me. Thank you.

Why did you still use the redistribute connected ? is the ospf advertisement of the loopback not enough? Because in redistribute connected command, it advertises all directly connected interfaces including loopbacks.

Why does R1's bgp config has no update-source lo0 command? Only in R3 and R2 does have?

why do u add loopback interface on router 1?

hi

This was great! Thank you very much for posting it, I have learnt a lot this evening

do you have to advertise network connected to other autonomous system from R2 and R3?

Easy to understand, the way explain that's great

Thank you for video👌👍

Sir its rare topix of ISP.

Great job..easy to follow, and thank you for explaining the reasons behind the solution

Thank you so much for this big effort Watch from sudan

Thank you sir... for this video

Hi, Thank you for this video, what simulator software are you using? Please? I have GNS3 but need help on getting the Nexus IOS. I await your reply.

Turn up your MIC... My volume is all the way up, and can barely hear your voice

You have covered this very detailed and good explanation. Good Job keep it up. Do you know if we can GBP deny statement before final cut over to avoid any outage ?

Hi guy I am configuration FEX between nexus 7k and nexus 2348UPQ. But After configuration successed, then I check port by command: show int brief, show fex 101 detail, ..... et... I dont see 6 port QSFP for ( nexus 2348UPQ). I only see 48 port ( Nexus 2348 have 48 port SFP and 6 port QSFP) Please help me

thank you for the video, but do you know where can the IOS for the N5K AND N2K

Too quiet! Fix your mic

Could we get more video of nexus and your full web series of nexus..what is name of your blog?

Thanks for clearing fex concept thoroughly.

hi, can you tell me how to emulate fex, did you use GNS3 ??, can you make a shared folder with all IOS for making a virtual lab like you, thanks in advance

why configured access vlan 930 in portchannel 78

Thank you out of all the video i have watch you were the most complete and detail vpc fex etc ... thank you a lot :)

Thanks for an excellent demo.. just to double check we need to create vpc for port-channel 1718 as well right ?

Thanks! great video

Hi, I need to configure a port-channel between N2K and BNT swtiches. Is it right this confgiuration? interface port-channel70 description link to BNT switchport mode access swtichport access vlan 1052 spanning-tree port type edge speed 1000 duplex full ! interface Ethernet151/1/26 switchport mode access swtichport access vlan 1052 channel-group 70 mode active no shut ! interface Ethernet152/1/26 switchport mode access swtichport access vlan 1052 channel-group 70 mode active no shut ! Thanks!