- 18
- 30 521
Jared Cleary
เข้าร่วมเมื่อ 15 มี.ค. 2014
How to replace brake pads on a 2006 Hyundai Tucson
This video shows specifically how to change the rear pads on a 2006 Hyundai Tucson. As mentioned in the video, the front brakes are the exact same process, using the exact same tools. This process will work on most vehicles as well, as many brake systems are 2 caliper bolts, compressing the piston, and adding the new pads
มุมมอง: 72
วีดีโอ
Ford Ranger thermostat replacement
มุมมอง 30วันที่ผ่านมา
This video was made from a 2001 Ford ranger 3.0. Process should be similar to other years and engine sizes. If you see your car temperature leaning towards the H side, this could be your issue. The thermostat can get stuck in the closed position, not allowing coolant to flow through the engine properly, leading to an overheating issue. Other problems that cause this issue are low fluid levels, ...
2013 Honda Accord Spark Plug Replacement
มุมมอง 162หลายเดือนก่อน
This video is how to replace spark plugs on a 2013 Honda accord 2.4L dream works engine. Most 4 cylinder cars should be a similar process, with a few variances on removal steps.
Replacing Honda Accord Tail Light
มุมมอง 30หลายเดือนก่อน
How to replace Honda accord tail light, brake light, and reverse light. This is a 5 minute job on my 2013 accord, hopefully it is similar for other years
How to fix a window that leans forward
มุมมอง 752 หลายเดือนก่อน
This video is how to fix a windows that had a slight lean to it. An off track window can cause lots of issues, including leading to a regulator failing. This is a quick temporary fix, especially if you are not able to find the part to purchase anywhere, which was my situation
Fuel Pump Replacement 2013 Honda Accord
มุมมอง 1.5K3 หลายเดือนก่อน
2013 Honda Accord Fuel pump replacement. A bad fuel pump will fail to deliver fuel to the engine, causing rough running, or no start issues. *UPDATE* 3 weeks later and the car is running flawlessly. Needles to say, this fixed my no start issue
How to fix paint scratches on your car quickly
มุมมอง 2.3K3 หลายเดือนก่อน
This video is to show how to repair clear coat scratches on your car. This is to fill in clear coat to remove any imperfections, if your scratch is deep into your cars paint color, then a different process will need to be done
Garbage disposal fix in 5 minutes
มุมมอง 2693 หลายเดือนก่อน
If your garbage disposal is not turning on, or making a hum sound, it’s most likely just clogged. Here are a few easy ways to fix it to avoid calling the plumber. Save $$
Warm AC? It may just be low on Freon
มุมมอง 3143 หลายเดือนก่อน
VOLUME WARNING: At 2:30 the engine is running and may be very loud from the speakers Always try to diagnose the issue before adding Freon. Do not add any of the level is over halfway in the green section, or the red. There may be another issue such as AC compressor not working, clogged lines, etc.
2001 Ford Ranger 3.0 Starter Replacement
มุมมอง 6553 หลายเดือนก่อน
This is a simple walkthrough of how to change a starter on a ranger. This should work for all 98-2012 models with the 3.0, and should be similar to the other engine sizes as well
2006 Hyundai Tuscon Radiator Replacement
มุมมอง 2.7K7 หลายเดือนก่อน
This is for a 2006 Hyundai Tuscon with a 2.7L engine. Process should be similar for many other models as well
How to put Wheel Spacers on by yourself
มุมมอง 38810 หลายเดือนก่อน
This video is to show how to tighten or loosen wheel spacers when you don’t have anyone to press the brakes
Ford Ranger Door Lock Replacement
มุมมอง 2.6K11 หลายเดือนก่อน
Works for Ford rangers and possibly other cars as well. No rolls required and as simple as a 5 minute fix
Chrysler Sebring AC Compressor Replacement
มุมมอง 2.6Kปีที่แล้ว
Chrysler Sebring AC Compressor Replacement
OMG thank you!
You got it! Glad I could help.
You’re welcome!
Why does Cadillac always make things difficult😮💨 this helped greatly though!
Cadillac always has to do something extra lol
Ice cold again! Thank you🙏
Anytime!
Could not figure out how to take this off, thank you so much!
So much easier than you’d realize!
Absolutely genius
Right!!
It’s so nice not having to worry about my temperature gauge anymore😅
It’s a scary sight when it creeps up to the H😅
YOU SAVED MY DANGER RANGER!
THE BEST VEHICLES AROUND
This was absolutely my issue, ice cold again!
Such a quick and easy fix!
So glad I could turn it from the bottom, was worried about sticking my hand in there!
It would not be my preferred way that’s for sure lol
My car looks brand new thanks to this!
It works so good!😍
Finally my window isn’t grinding anymore lol
Mine was doing the same thing lol, rough on the ears and the glass!😂
Yayyy! Cars can see me again😂
Congrats!😂
I’ve already seen an increase in my MPG in a day, mine worn very worn😂
Isn’t it great saving money🤑
You saved my overheating issue🙏
@@StormHB10 gotta keep those rangers running!😅
This is gold!
Glad to help!!
Just helped me replace mine! Thanks so much
Great to hear!
Good job
@@SammyRuiz-y6w thanks!
I dont have a sunroof on my 2005 cts and my back floorboard is still wet!
This video was money! Thanks from North Dakota!
@@eddie.guerena1981 glad I could help!
Not all heroes wear capes. Thanks man mine just cracked today and was hoping someone did a tutorial.
@@joshvisel182 Goodluck man. I will say that my existing cooler lines didn’t thread into the new radiator well. So use the new pieces they give you and attached them to the existing lines. Should be metal inserts into the rubber hoses. Hope that explains it well🤞🏽
Thank you 🙏🙏
You seem to have a problem with your ABS module considering all those lights on the dash..... In my case i first encountered the fuel pump (stalling) problem and soon after the ABS module issue came around. I wonder if those two issues are related.
@@mrkolyan12 yeah I’ve read that with this generation of accord the ABS module can throw all those dash lights. Honda should’ve recalled that
theres a way easier way i’ve been searching for weeks on how to install a double din in 03-07 cts, its a PAC wiring harness and it makes it plug play with any head unit, its on amazon the name of it is “ PAC Onstar Interface for 03-07 CTS & 04-07 SRX “ has no rear speaker connections tho so i just tap those into the front ones like front left + and rear left plus from your aftermarket head unit harness go with front left plus on the harness for the car and so on and so forth
Great video. When the your car stalled at a stoplight did it happen suddenly or did it start shaking before stalling?
@@juanitobananas87 so it’s shaken before at stop lights but never died. This time around it just stalled completely without and shaking. I didn’t even realize it was off until I saw the RPM at 0
YA It's called a suiside can for a reason dumbass, low and high Pressures are a corelating factor with temp. Higher ambient temp = Higher presures, don't just drop a can in without looking for pressure, temp diferentials,, there are charts for this, google it.
they say you should not put too much in makes pressures too high on compressor and such.
@@ranger178 definitely! That’s why I’d recommend to make sure that your compressor and everything else seem to be working. If it’s already around 40-50 PSI, you do not need to add anymore, it’s probably a different issue
Hey bub, what color is what, when u take out the factory radio,I don't have no wire harness..
The easiest way to check is to look up the wiring diagram. A Cadillac forum should have it, that’s where I found what colors mine were
@@TheGarageDoc ok cool,well I finally fixed it about a week ago,but thanks for responding back bub.
nice...i will do mine soon. thANK YOU mate
Goodluck!
Cool you had the bolts undone. We wanna see you take em off. Lol wtf
@@seanballard2062 I showed you the location and the size…. Just put a socket and ratchet on it?😂
That's I love like that eat explanation and fast
Goodluck!
Will this work on an '09 Ranger?
Did you change your speakers? I thought I read somewhere that the OEM speakers are different ohm than what aftermarket head units can run. Maybe that’s just Bose systems though…
I used my stock speakers and didn’t notice a difference
This was a great step by step removal/installation video. I appreciate your time. Thanks.
@@JasonGordon-y4c glad I could help!
This is gold. I took the whole door panel off, realized it didn't help me, and then watched this video.
If only you had watched this first!😂
Great video thanks for the help man
Glad I could help!
So are you just not able to use the factory amp when you install an aftermarket radio? I need some explanation I’m just confused why you can’t tap into the connector coming off the back of the radio
Yeah it’s a bit confusing. When you put a new double din radio in, it comes with a wiring harness, because not every vehicle has the same connector. So the normal 8 wires ( 4 speakers each a + and -) that you connect the new radio to are usually the back of the radio because they usually have an amp inside them. But if you skip to 3:01 on this video, you’ll see that those 8 wires are actually in the trunk instead. And from the trunk, they run wires to the speakers. So the route I chose was to take 8 wires and run them from the new radio up front, and then go to each speaker from there. I hope that helps explain it some
Such a great step by step video no gimmick no extra conversation just the ends n out on how to fix the compressor THANK Y.O.U😅🎉
Yessir! Glad I can help🎉
Those wires in trunk are the output wires for sure? I don’t wanna tap into them and be the wrong ones…. What wires are for the tweeters and center speaker? I wanna tie those into door speakers
Yeah all the colors coming out of the amp on the big connectors are to each speaker. I can’t tell you for sure the colors but if you check the wiring diagram it’ll say something along the lines of “rear center speaker (+ white/green) ( - red/black)
pinoutguide.com/Car-Stereo-GMC-Opel-Chevrolet/Cadillac_2002-2008_CTS_BO_pinout.shtml here’s all the outputs. Definitely easier to understand with the pin labels instead of just using the colors
So what would happen if you remove the factory amp?
You would have to buy some sort of adapter because the head unit does not have 8 wires (4 speakers, each with a + and -) coming out of it. Cadillac did not make it easy for radio swaps
@@TheGarageDocI already have an aftermarket system installed. 2 Ct sounds strato 12’s on a recoil 2500.1. I think the factory amp is the reason for the humming coming from my subs.
@@guestguestthat would usually be from a loose ground or loose RCA connections
Hi, can you reuse the clip that is attached to the bar? Mine did not come with the plastic clip. Thanks!
I don’t see why not. I’ve never tried to take it off so I can’t say for certian, but if yours didn’t come with one that makes me think that they can come off
Where did you get that dash kit? I can’t find one . Did you order it on line?
I ordered mine on Amazon. Just typed in “2007 Cadillac double din dash kit” and it was on there
Love this video bro, no BS and straight to the point, I have the same car and there's no ac right now and the convertible top stopped working.
These cars seem notorious for the top not working😒
Can anyone recommend how to remove to clutch to bypass the ac on a 2010 2.4l
I have a 2006 cts and mine is so different
Is the head unit a completely different shape?
I cant just use a wiring kit to connect behind the dash? Like some other cars.
This car (and possibly all Cadillacs) is very different from any other one I’ve dealt with. I’ve always been able to use a wiring harness to put on a new double din, but I could not find one that was even made for this car. This car also uses more than just one or two factory harnesses (as seen in the video) so I think that is what makes it difficult to adapt to a typical double din radio which just has one or two connectors
So there is no wiring harness for a 2004 cadallac CTS?
@@paulherdon1678I searched everywhere and couldn’t find any for the 07, and I believe the radio is the same for 2003-2007
My tubes for the sunroof was disconnected on my 06. Took me forever to figure it out 😂
May have taken forever but at least it didn’t cost you much😂
😊 "PromoSM"