วีดีโอ

This is another problem I have had for several years but never got around to fixing it. The lift gate will not lock and even if you do open it when it is supposed to be locked the alarm does not go off. I take the plastic cover off and investigate the problem. I believe that the lock actuator needs to be replaced.

This is a vcr tuner module which I have connected to a beagle bone black via i2c. The purpose would be to control the intermediate frequency produced by the tv synthesizer chip.

Watch for when the rpms drop and quickly jump back. I know my catalytic converter is bad so could this be caused by it? My idle air control valve and tps have both been replaced recently.

I created this video with the TH-cam Video Editor (th-cam.com/users/editor)

2001 jeep grand Cherokee limited 4.7L V8 Jeep will idle very low and fluctuate. Jeep also has p0456 engine code which is small evap leak detected.

My Jeep has had an AC fault code of 52 for some time now. I finally got around to investigating it.

4/26/12

This is an overview of a webpage that is being served by an arduino ethernet shield. The webpage simply toggles each LED on and off. Let me know if you have any questions about the networking behind this because I think that is the hardest part about this. Here is the link to the instructables webpage where I found the code: www.instructables.com/id/Ethernet-Shield-LED-WEB-SERVER/

This is an old Hitachi V-423 40MHz oscilloscope that was given to me. It has a problem with the Volts per Division knob that causes odd fluctuations in the traces. Any advice on how to fix it will be greatly appreciated.

This is what happened to my oscilloscope after I attempted to measure the mains wall voltage. It now has a slightly curved ground trace instead of a true flat line trace. LOOK CLOSELY!!