วีดีโอ

Sem ponteira não dá. 🇧🇷

これと同じカラーリングのCB1100F探していますが、いい車両がありません。あれば教えて下さい。音も素晴らしいですよね。

すげー、一発

マフラーで右後ろのウインカーが後方から見えなさそう。 キャブレターの同調が狂っていそう。 知らんけど。

Well done. I'm curious as to the front end setup

Hey goofy put the pipes back the bike they make loud pipes that are still there Goofy

子供じまん？

Please put a proper pipe on the motorcycle.

I'm always ranting about people sticking fugly '90s-Y2K+ crotch-rocketry all over a Classic Superbike, bastardizing it into a STARBUCKS RACER with the USD forks & 17" cast wheels & floating rotors and all that other bullshit - But for NOW, let me address the hydraulic clutch. There's a huge chunk of space under the cover, taken up by the mechanical clutch actuator. Enough space that you could hide the hydraulics INSIDE the cover, and run the line to the perch out through the side hole where the lever arm used to pivot. But let's say you WANT that slave-cylinder on the outside face so you can show it off? Well then why not CUT DOWN THE COVER? You could file down the entire chunk of the outer lip edge such that it's only around 1/8" wide/tall instead of the inch or thereabouts worth of width that's WASTED by leaving it as it stands. If you cut the cover down, the hydraulic slave-cylinder will only sit as far outboard as the outer face of the clutch-cover was in the first place! So EITHER which way, PERSONALLY I'd prefer to see the hydraulics hidden inboard as a "Stealth" modification - But just don't leave it like THAT with the full-width cover AND the slave-cylinder on the outside! Right?

This thing is a beast !

カッコええ～～～。俺も次はCB750かZ900RSかな♪

Buityfull Bike..Nice job!!..Love it.. Please tell me what fork you used?

holy shit!! please do something with that horrific Bazooka muffler. nice bike but ruined by the pipe. don't know if I should thumbs up or thumbs down, so i'll not bother to do either.