วีดีโอ

Powerdisk refilling used to be a contact sport, but, due to "safety regulations" it just doesn't have quite the excitement it used to have, unfortunately.

I feel your pain! Hang on to those and use as needed, refill as much as you can. That's what I did with the pack that came with my washer.

Perhaps try some of the Cascade Professional powder; that is what I have been using and have had good results when compared to the Miele powder.

Experiment a bit, try a different powder - try a cheap powder the next time. My results with 'cheap' powder here in Australia (Aldi Logix powder) is just as good (if not better - read: cheaper) than the Miele powder it replaced. Miele powder isn't the be all and end all of dishwasher powder, if it was it would be sold in every Supermarket as well not just on the Miele online store.

@@s-clan5266 i assume the power i used is to big grained and it falls not good out the powder you use must hafe smaller grains true that

You can try pouring some warm water down the channel (slowly) and it should clear any powder that is clogged. There is a little door at the bottom of the channel that opens/closes as needed and this getting hung up can cause the error.

Yeah, hang on to those. I got 6 "free" when I bought my washer and still have 4 of them. They were asking $20 a pop at my local store, I am glad I figured out how to refill for pennies!

I chose to drill the side and not the back to aid in filling. The back would work as well, depending on the fill method. I would recommend not using aluminum tape as my experience is that it doesn't adhere or have enough flexibility to provide a good enough seal, especially when exposed to the heat in a dishwasher. I have been using T-rex tape (duct tape on steroids) without any issues with sealing or coming off. Also, keep in mind, that the factory hole is always open and exposed to the environment inside the power disk chamber.

None at all. I have been using Cascade Commercial (orange box) detergent.

@@HASTE347 where are you getting it from -looks like they discontinued the fryer boil out product

@@mirek79 This seems to be the closest I could find at Amazon... www.amazon.com/Cascade-Platinum-Rinse-Packaging-Vary/dp/B07NS85T5J

I think you may be confusing Klarspüler with Rieselhilfe...

My model has a rinse aid container that is separate from the powder. I have not experienced any issues with cleaning or leaving water spots on my dishes and the water is fairly hard in this city.

the original powerdisk although use rinse-aid we need to refill it eventhough we use at the moment the 6 powerdisk for free pack.. and special powders hafe rinseaid too its just marketing i guess

​@@mcbriteRieselhilfe = Trickle Aid. Klarspüler=Rinse Aid 😁

There will be at some point I am sure. These are relatively new to the market (released around mid 2020 I believe) and very niche, so it's high-hanging fruit at the moment. There is enough clearance to add a solid cover to an existing disk. Alternatively, the disks could be 3D scanned/printed fairly easily with the correct equipment. If I ever get around to acquiring said equipment this will definitely be on my things to do!

You know if it stuffs up and you have to have a service, you could've voided your warranty!

@@drewmarshall7211 what could stuff up it's still an original power disk holder

@@drewmarshall7211 before the technician comes buy a new one and say that it stuffed up 🤭

Just get a 3D printer ;D

None so far. My mechanic said he ran into an issue with the cats when he installed the Ultracharger, FWIW.

A little over a year, best mod by far!

Yeah, I got the shroud from Florida50, but they didn't have the nexus kit back then, so I ordered them all separately.