วีดีโอ

Thank you for your question. Yes, you should flush your equipment out after it is used. When using a 2K system, you should flush after every use to prevent a coating from hardening in the system. For 1K systems, flushing is still recommended at least once a week, often on Friday so the coating doesn't have a chance to settle over a weekend.

Hi Erik, thank you for your question. It's always a good practice to have the needle on the gun wide open, full potential, then set your fluid stream. Depending on what you are painting, a 12-18 inch stream is a good starting point. If you need to cut back, you can dial the needle in a few turns. Keep in mind, if you continue to run with the fluid needle turned in, you will ruin the needle and nozzle of the gun.

@@DiamondVogelPaint thank you for that information. So do you think it's better practice to try and fine tune off the pot? That's why I try my best to do.

Thank you for your question. The spray gun used in the video is a Graco AirPro HVLP pressure feed gun (Model is 288938) with tip size 1.4.

Did you find out where to purchase fresh air supply respirator system.

@@eket9958 no unfortunately,highly appreciate it if you you can send me the name of the store or the link. Thank you

Thank you for your question. The mask that is being used is a 3M PAPR unit with a SAS washable paint suite.

@@DiamondVogelPaint thank you

Thanks for reaching out, and we’d be happy to help in whatever way possible! We do manufacture both a waterborne 2K wood coating and a wrinkle effect coating for metal. Please send your contact information to info@diamondvogel.com, and we will have someone contact you with more details.

Hello, Ricardo. Thanks for reaching out! It sounds like there could be a few different things going on. To better understand the issues you’re having and to hopefully give you some expert assistance, please reach through the contact form on our website: www.diamondvogel.com/industrial/contact. Thanks again!

More pressure! If not may need to use a little bit more thinner. Been coating for 5 years and i like my epoxies and paint to be a little watery not to much obviously it wont dry properly or you’ll get runs but most of the time thick epoxies may just need a bit more thinner or more pressure. Hope this helps. I used binks pressure pots. P mix systems. Ultra max 2 graco and graco bulldog airless and bulldog with minimal thinner on epoxy shoots good. Just an expensive rig is all.

You need put or mix the suitable solvent in your epoxy through standard ratio.