วีดีโอ

not my vehicle but the 3.4's are good motors!

@@MTB539 25lb ft 8mm bolts

dorman parts are not very good quality

@@jeremyparks9648 it was just rusty

@@brocka.stanley6072 car is 4r70w swapped never been a dyno and never to the track yet

some are easy some are a pita

pressure transducer or cruise control cancel switch is what the parts store calls them here is the MOTORCRAFT part number SW6349

customer supplied the parts.

its not very hard

yep makes sure its sealed up for no come backs..

3.5 ecoboost

@@briansfixinstuff I said that and then didn’t recognize the dipstick location. Common issue with upgraded B58 HPFP’s too

@@ianbehm4837 probably all the same fittings.. i just bought this pump used about a month ago and kept smelling fuel when the hvac was on.. finally showed a major leak this morning when the temps got down to 35* out last night.

@@emii4233 pretty sure it was the Dorman set that’s sold on rockauto

@@brunokorytkoml.8501 no anchor plate was all rusted and caused the pad to get stuck.. cleaned anchor plates and new hardware pad floats properly now.. but that can also be the cause of this.. frozen slide pin.

@@briansfixinstuff oh, that is, brake pads stuck in the holder

@@David-zq4ih it got new pads and rotors

Thank you the truck was restored about 8-9 years ago now.. i had a modified 7.3 idi in it. just put the 7.3 psd back in..

@@briansfixinstuff nice

All the car manufacturers make junk.. this is a gm product tho

@@zacheryficinus5550 fwd only don’t have rear axles

wait till you gotta get that ball joint nut off..

they actually were tight..

why not

i use wheel bearing grease any grease is better then the minimal amount they put in when making the parts

@@marcosramos4596 it’s not recommend and they don’t sell all the bushings

@@briansfixinstuff how much was the new Knuckle?

@@marcosramos4596 not cheap I believe like $300 each I’m 100% sure on that part

Thanks, It’s called a searching hood light

@@briansfixinstuff was it originally an interceptor that you just customized?

@@domwhitener9014 no its a sport model its the performance model

@@briansfixinstuff I have the exact same in white, I was only asking cause of the roof rack delete and the side mirrors and door handles were a little different, unless you put some wrap over them, my door handles are originally chrome but I bought these carbon fiber door handle covers and the white and black just goes so well, I also ordered that light you told me about and thank you so much bro

@@domwhitener9014 i took the roof racks off and i have carbon fiber wrap on my mirror caps rear spoiler and door handles

@@darkfalcon75 you in the rust belt.. everything needs heat these are also 8mm, you put a 3/4 impact on an 8mm bolt.. didnt know they had a 13mm socket for 3/4 drive

not always

@@jesuscarrillo2789 you don’t need audio to watch

The job never came back so I’d say it’s good

if its leaking then you know its got oil in it lol..

There’s many reasons for letting Americans know about replacing pads & rotors. But you should remain silent & not be thought a fool.👍

i just post my daily work as a mechanic.. dont like it move on..

@@papawd3991 both you guys should butt fuck each other while standing on top of a box of AutoZone brake pads for a 88 Chevy chevette

@@papawd3991 your reply was so trash 🗑️🚮, as trash as this video.

@@inductor1.77 I’d replace it don’t need it to blow out and you loose all ur oil.. this isn’t my truck a job I did for someone

you can turn it down. or mute it. im not much of one to talk on camera.