วีดีโอ

best video so far.. everyone uses a hammer and some special cylinder looking thing... this is awesome.. i can do this on my bench .

Good Job! Thanks

You don’t grease the driver bearing?

With the thrust bearing , which side do you install it on ? With the bearing facing the shoes or away from clutch

I bought my Titan premier clutch new and it’s set up for outboard but I run inboard, if I slap it in without changing anything will it mess up the clutch?

with what tool would i remove the hub snap ring with? i have this red tool but it doesn’t open enough for the ring to pop off any suggestions ?

Awesome video, thanks! I currently have a major issue and was wondering if you can help. I have a 2020 TB Kart with a Tillotson 225 motor. Using this clutch makes the chain rub against the seat chassis frame. You mention reversing this clutch to make it inboard. Can you share this video? I’m not too mechanical but willing to learn.

You need way better lighting

Great tutorial! No grease on the bearings or bearing surfaces ?

Is there anything you can do to reducing the dinging of this clutch with something hitting the housing and it sounds like a dinner bell?

Would you guys have some other videos to upload of this Dyno? Would love a closer look at the data it produces, etc.

Chris I have the same two questions as Bennett Taylor below, for some reason I can't see your answers.

Excellent video. Thanks for the great explanation of clutch work! Looking forward to the next video.

Big Steam!

Chris, I find often the slots that segment portions of each shoe get filled in partially with shoe material sort of spreading across the gap. Is this something that is important to address also when knocking off the glaze? If so, what is the best way you have found to clean that up? Is this a normal type of shoe wear or is it a symptom of another problem? (I noticed your shoes weren’t showing this type of wear) Lastly, how do you determine when it’s finally time to replace the shoes and/or the drum? Btw, great video!

Chris, do you sell the tool that you used to chuck the drum into the drill? If you want to reach out directly, you can hit me on Facebook messenger.

#snapyaneck 💪💪

30 Yeeeaaaarrrsss!

Thanks for the shout out!!

OL Big Steam Himself