วีดีโอ

This solution is exactly what I needed. Thank you. In my case, the gate post is too small for wood but made of substantial aluminum, so I used a 1/2" threaded rod, fender washers and lock washers, and a nut. Drilled through the post so I could get a ratchet through and tighten each side against the other and draw it tight. Worked like a charm, and I wouldn't have thought of it without having watched this video!

Pretty sure this is best solution I have found anywhere, been looking for months! You obviously know what you are doing since you built your gate. Gonna try to slow down video so I can understand better. You kind of lost me! Thanks for posting this!

Nothing against you/everything against Ford: I absolutely love the mixture of imperial and metric while doing this 🤦‍♂️🤦‍♂️🤦‍♂️ (I'm at the point where I'm removing the brake line, which I have to do with an end wrench because there isn't clearance for a ratchet)

Home Depot sells the kits. About an hours work start to finish.

Good stuff....how'd do it the right way ✅️

I subscribed. This is exactly what TH-cam is for. Thank you

Great idea thanks!

Amazing. Thank you for this idea!

thank you so much for putting this out there. I was planning on using a turnbuckle... but as you said, I anticipated that it would not look acceptable. after searching for a better way I stumbled across your video. my search is over. this looks like the way to go for sure. thanks again for putting this out there. but

Thanks for the vid, it was a great help for me and my buddy who did it yesterday. It may have took us a bit longer, 9 hours!! And we had a lift! We ran into some roadblocks and never gave up and never would have been able to do it without your guidance.

thank you Car Fan for posting. I absolutley could not find another video out there on the rear seal change on my 2011 ford escape AWD.

Thanks for the great advice/video. How hard was it to push the axle back in ? Any tricks ? I will be doing this job this weekend right after I buy one of those porta powers. TIA

Only video I could find that comes close to a 2011 escape. Need to do the same seal on mine