- 73
- 15 100
atvsmurf
เข้าร่วมเมื่อ 26 ต.ค. 2011
Channel to collect and share videos documenting life, projects and play.
วีดีโอ
JB Weld windshield repair kit on H3 Hummer
มุมมอง 3804 หลายเดือนก่อน
Created by InShot inshotshare.app
Meguiar’s Hybrid Ceramic on a Deere
มุมมอง 1.5K4 หลายเดือนก่อน
Tried out Meguiar’s hybrid ceramic spray wax on our John Deere 1025r. The paint was in good condition, but not maintained or cared for. It worked well for a 2 second wax job!
First harvest at Travelers Farm!
มุมมอง 114 หลายเดือนก่อน
We pulled 2 frames during our first split. This beautiful amber nectar is the result!
Mowing around a beehive!
มุมมอง 584 หลายเดือนก่อน
Fielding a question…does the mower make the bees angry? No. I have no trouble mowing or weedeating around my apiary.
Beehive frame corners.
มุมมอง 284 หลายเดือนก่อน
We popped the corners off the new frames. This should allow the Queen easier access to both sides, to help with laying eggs.
2018 Volvo XC90 t5 Purge valve replacement
มุมมอง 4454 หลายเดือนก่อน
Replacing the purge valve. The car was hard to start after refueling, due to a faulty purge valve, allowing fuel vapors to enter the intake; flooding the vehicle. The repair took less than 5 minutes using a $70 part. McrGinly Carbon Canister Solenoid... www.amazon.com/dp/B0D2KCZ8WS?ref=ppx_pop_mob_ap_share
XC90 Airtube replacement.
มุมมอง 724 หลายเดือนก่อน
Replacement of the plastic air intake tube running behind the engine. The part on our 2018 t5 decided to fall apart, resulting in a huge vacuum leak and codes P0455 and P04F0…plus the P0171 bank 1 too lean code, followed by P0172 bank 1 too rick codes… #travelers #farm #volvo #xc99 #t5 #atvsmurf
Rinse aid comparison. Formula 4 vs Hybrid Ceramic
มุมมอง 2.1K4 หลายเดือนก่อน
Testing Meguiar’s Hybrid Ceramic Spray and Superior’s Formula 4 spray wax as rinsing aids.
Splitting My Hives Part 6
มุมมอง 234 หลายเดือนก่อน
I split my hives, my first time. I broke the video into several segments, watch one or watch them all! Like and subscribe.
Panamera transmission mount replaced in 5 minutes!
มุมมอง 1524 หลายเดือนก่อน
Panamera transmission mount replaced in 5 minutes!
Panamera Executive turbo rear cup holder fix!
มุมมอง 2045 หลายเดือนก่อน
Panamera Executive turbo rear cup holder fix!
Former site of McMurphy Mining,Big Branch rd, St. Charles VA
มุมมอง 335 หลายเดือนก่อน
Former site of McMurphy Mining,Big Branch rd, St. Charles VA
Какая проблема была со старым клапоном?
How did you refill the air struts?
Can you just spray formula 4 then dry with your towel? Or do you really need to spray water after you lay down formula 4?
Nice work 👍 The bushings on those upper arms were toast.
Terrible Video & sound 👈🏻
good information, thanks for the video!
excellent video much appreciated!
FYI when using a rinse aid spray water from bottom up, same applies for wheels.
Is this the Evap valve?
Good question I have a xc90 t6 with p04f0 code and I wanna make sure I have the correct part number
The hydraulic hoses shouldn't be going over the top of the frame like that. It increases the risk of damaging the hose and might cause it to shoot the hydraulic fluid when it's under pressure. The hose is supposed to go straight out the rear of the frame under it. The manual mentions it, and pretty much all of the videos on TH-cam also say how to route the hoses.
When you took off the strut airlines did any air release?
Very little air escaped. I set the ride height to the highest position, placed it into service mode, then raised the car. So very little air actually came out as the shocks/bellows were extended. After reassembly and before starting, I lowered the car back down to what I guesstimated was ride height…Started her up and took it out of service mode. Kept it from throwing a fault, as the system didn’t have to work hard to pressurize the struts then pressurize more to lift it back up.
Good video. I have a "vintage" 2008 XC90 V8 Sport so I always check out videos on them when they pop up on my feed. New sub! Take care.
Thanks! This our first…I love those..they seem to sit a little higher.
Where did you buy CVT belt?
Sorry for not responding!!! I never needed to replace the belt. It was a cf moto drivetrain. Should have been available online… The mechanicals were solid. The electrical parts were the issue. I bought it not running. Replaced several relays(matched with a sportster fuel relay) and it fired right up. I made it a point to open any connection, clean and apply dielectric grease before reconnecting them.
Nice trail. Just walked it all the way today. The first trail I've ever been on. Hoping to walk more trails around there soon.
Thanks, just now seeing this…lol The trail system is great and well maintained!
Do you like your uvt
Utv
It was great with one flaw…the kid that owned it before put a 2-stage racing clutch in it. It would intentionally slip then grab hard. Reusch has electrical issues…many can be solved with dielectric grease… Sorry for the delay in responding.