- 14
- 140 251
T C
เข้าร่วมเมื่อ 14 ต.ค. 2012
2001 Ford Ranger AC Fix, A Must Watch
This is a 2001 Ford Ranger with a 4.0 L engine but it should be the same for all engines. This is a simple air conditioning fix before you spend money on the compressor. Fuse number 17 (20 Amp) is for the DLC(I inadvertently called it a DCM), but it enables the compressor to start running. You won't find this on any schematics or I should say any easy to find schematics. There is also a fuse and a relay under the hood. but this one should be checked as well.
If the fuse keeps blowing then at least you will know what circuit to chase.
If the fuse keeps blowing then at least you will know what circuit to chase.
มุมมอง: 7 006
วีดีโอ
Dodge Ram Heater Motor Replacement 1994 - 1998
มุมมอง 130ปีที่แล้ว
This is a quick video on how to replace the heater motor on a second generation Dodge Ram. This truck is a 1997 3/4 ton diesel. I apologize the first 10 seconds of the video are on time lapse, It was unintended. The back bolt on the heater motor was by and far the most difficult part of the project. For me, using a swivel attached to the 8 mm socket and a long extension really helped. The venti...
Oregon Coast Beauty
มุมมอง 842 ปีที่แล้ว
Oregon coast September of 2022. Newport to Cape Disappoint Washington. Simple video showing the picturesque scenes along the coast. Newport Seaside Pacific City Depoe Bay Astoria Cape Disappoint Embrace by Sappheiros | soundcloud.com/sappheirosmusic Music promoted on www.chosic.com/free-music/all/ Creative Commons Attribution 3.0 Unported (CC BY 3.0) creativecommons.org/licenses/by/3.0/
2nd Generation Dodge Ram AC (Air Conditioner ) fix.
มุมมอง 29K2 ปีที่แล้ว
Quick video on a potential air conditioning fix for a 2nd Generation Dodge Ram. I had checked all the fuses and relays for the AC when my compressor quit engaging and all I got was warm air.. But after lengthy research I found that the 20 Amp "Horn" fuse, located under the hood, is also tied to the AC. If this fuse is blown the compressor won't engage. As soon as I put in a new fuse it started ...
1999 Toyota Tacoma LED Bulb installation
มุมมอง 10K2 ปีที่แล้ว
Installing LED bulbs into a stock headlight housing unit on a 1999 Toyota Tacoma. This is a very simple video showing the benefits of LED bulbs over Halogen bulbs. I'm just a do it yourself guy and I think about anyone can do this. LED light bulbs are installed in the stock reflector housing unit. Before and after videos of LED vs Halogen lights from both driver and oncoming traffic's perspecti...
Learning to drive a stick gone wrong.
มุมมอง 572 ปีที่แล้ว
Older sister teaching little sister how to drive a stick, lol
2007 Toyota Avalon LED lightbulb installation
มุมมอง 28K2 ปีที่แล้ว
This is a quick and simple video on how to install LED light bulbs in your third generation Toyota Avalon. This covers the 2005-2007 models. The "high beams" are halogens with a projector style housing, so it's basically plug&play. The "low beams" are HID, so you cannot install LED bulbs without removing the ballasts, etc ... The last 30 seconds of the video shows the comparison between the hal...
Cell phone charging issue fix
มุมมอง 1872 ปีที่แล้ว
In this video I show one way to clean the charging port on your cell phone. Many times our phones are in our pockets or purses and the charging port fills up with lint and other debris. If you've noticed your charging cable doesn't feel tight when you plug it into your phone, or it doesn't seem to charge very good or consistently, this may be your issue. Just make sure you use something plastic...
2007 Toyota Avalon fog light (bulb) replacement
มุมมอง 5K3 ปีที่แล้ว
This is a simple video on replacing fog light...light bulbs on a 2007 Toyota Avalon. I replaced the oem bulbs with LEDs. This isn't the best video but it shows you the basic steps to replacement. Took me about 5 minutes to do both sides. LEDs look a lot better in my opinion.
1999 Toyota Tacoma rear shock replacement. 1st Generation Tacoma
มุมมอง 5K3 ปีที่แล้ว
Rear shock replacement on 1999 (1st Generation Tacoma). This isn't a professional video, but it does show you one way to replace your rear shocks. You DON'T need a lift, jack, jack stands or any special tools. You basically need a 17mm wrench and a hammer. It took me approximately 20 minutes from start to finish. This is a simple "how to" video, I probably made mistakes, but the point of the vi...
2006 Mazda 6 downstream O2 sensor replacement
มุมมอง 18K3 ปีที่แล้ว
2006 Mazda 6 downstream O2 sensor replacement. There was a P0431 code on my daughters car. This can either be a faulty O2 sensor or an issue with the catalytic converter/manifold. So we started with the cheaper option. I know this isn't the best video, but hopefully it helps you.
2002 - 2007 Mazda 6 Oil Change, 3.0 Liter V6
มุมมอง 4.4K3 ปีที่แล้ว
This is a very simple video on how to change the oil and filter on a 2002 - 2007 Mazda 6 with the 3.0 liter V6. The video isn't the best quality as I was trying to film and change the oil at the same time. But it gives you the basic knowledge to complete this task by yourself.
Windshield washer fluid, topping off. 2006 Mazda 6
มุมมอง 1.4K3 ปีที่แล้ว
Windshield washer fluid, topping off. 2006 Mazda 6
1993 - 2002 Toyota Corolla Heater Core Replacement
มุมมอง 30K4 ปีที่แล้ว
It is possible to replace the heater core on your 1993 - 2002 Toyota Corolla without removing the dash. I couldn't find a TH-cam video to help so I tried making my own in hopes of helping someone else. This job took me a total of 7.5 hours. I know this is a pretty bad video but it does show it's possible with rough instructions. I have a Haynes manual I bought at AutoZone for $25, it gives all ...
It is possible, so is going to Mars. I won't be doing either!!😂
What’s the name of the bulb can I get it at autozone. Thx
Battery has to come out for driver's side.
Thank you so very much for the video you did excellent
Problem I'm having now is everything's on. I can barely feel the air but there's no air blowing out. But AC I can feel it heat. I can feel it nothing's just blowing and there's no rattling or any other noise besides the normal air noise
Thanks ❤
man i cannot get the lightbulb off for the life of me idk how y just flicked it off with just ur thumb like that, mine wont even budge
Was that bank 2 sensor 2?
My AC works sometimes (blows cold air) otherwise sometimes it just blows warm air. Is this what yours was doing? Nice vid!
@@BenKleinCreates yeah, the compressor wouldn't engage so the air was warm.
My fuse box looks a bit different and the 20 amp fuse is a small one. I have a 5.9 magnum would it still work? Or is it the relay i should switch?
@@McChief1993 to be honest I'm not sure. I just know what worked on my Dodge with a Cummins engine. And hopefully it's a similar type problem so you don't have to spend tons of money to fix it
Thank you very much, extremely helpful
My horn fuse was fine but when I put it back in, it worked hahahahaha thanks!!! I have replaced so much too haha
Brother I just got done replacing my compressor and accumulator and then I found this video and it worked! Thank you so much , love from cali
Fyi for anyone attempting this and is stuck trying to get it out. The 2 heater core tubes get stuck to the firewall plastic from the hot water inside the heater core and literally are glued to the firewall. Use long bars or screwdrivers to pry it out gently.
Hi. Can the job be done WITHOUT having to unbolt/remove the evaporator(aluminum)? Thanks.
what if your comp works and it has refrigerant in it and everything is working but it still doesnt blow cold but only mildly cool?
@@butterbean4195 a small refrigerant leak is the typical reason it quits blowing cold, you could have a faulty compressor or a damaged condenser.....
@@T.C.. yea im done with it for now. im gona save up and get everything new so i dont have to worry about it..
I sure wish it was that easy. It’s not my problem.
Would have loved to see the cover put back on.
Thanks I’ll give this a try
20 cents you can go to the junk yard and pull them and throw them in your pocket but most times you always check your charge on the refrigerant i have had to replace mine with one from the junk yard bc there its $40 compared to over 300 new
Man your good✊🏼 been tryna figure this out for over 2 years and that blown fused fixed it👌🏼
Wicked thanks worked for my 1996 360 magnum
No way, I gotta try this, I got the same model 318 though.
Womp womp didn't work.
Awesome video man, very straightforward. Helped me out a ton. Thumbs up!!
Muchas gracias amigo, por mostrar que fusible es,
That would make sense why my horn also stopped working. Trying it now
Thank you very much. This was my problem
So is it a BLOW horn? 😂
Great video!
Добрый день, не могли бы вы расказать как поменять фарингейты в цельсий??
YOU SHOULD HAVE READ THE INSTRCUTIONS!!!__ as you installed in incorrectly. The Collar on the LED is supposed to be removed and mounted by itself, then install the rubber dust/weather cover, then push the LED through the dust boot into the installed LED collar and twist to lock the LED back into its collar. The mount and light will work the way you did it but you lose the weather boot with your method.
are they still working?
Yes, working great
Great vid thanks.
This odd helpful and a little intimidating as I gotta change the heater core on my 92 Corolla. I will be referencing this epic video!🤘🏻 thank you for taking the time to make this
Does your high beam indicator dash light work?
Yes it does
@@T.C.. Mine doesnt, and I dont know why. Thx..
Thank you.
Can you share the site from where you ordered these?
Amazon
Thank you
When I install one LED light it works when I install both of them one side won't work. What's the deal
A mechanic told me several years ago that an engine is easier to change in a Toyota Corolla than a heater core.
Thank you T C! that helped!
Thank you!!!! It took me no time at all and as you said I didn't remove my battery.
Good very and it’s straight forward to the point. Nicely done 👍
How come everyone show to do easy one why the hard like driver side I can’t change my drivers side because there is no space between the battery and the light I can’t even fit my finger tips in there
Get somebody with really thin hands. It can be done. If not, then move the fuse / relay box. Problem is that one of the bolts may be underneath the battery platform. This is how they design stuff.
I do not know how and where you take out light bulb, I only see your hand and old bulb. Are you Magician? Bad Video.
It worked on a 2001 Durango R/T 360 5.9 ... THANK YOU!! this saved me in this heatwave in the Midwest right now! my truck is all black..it was about 140 degrees inside of it
Hey man do you mind telling me what kind of issues you had going on ?
@zrymic563 it was just blowing out nothing but hot air with the ac on.. and it held a free-on charge... so it had to be something.. the fuse fixed it instantly. .mine is a 2000 durango RT
@@walleyworld Thank you. I have a 2001 dodge 1500 the ac blows cold but doesn’t blow to the full capacity i think it should be blowing. I’ve replaced the blower fan, evaporator core, heater core. So, i dont know what else should i really replace
@zrymic563 definitely try the fuse!! I had an issue with the security factory security system when ac wasn't needed.. so I pulled the horn fuse so the alarm would quit randomly going off.. never thought about it again untill I seen this vid.. hope it works bud!! August sucks here in the midwest! 💯💯🥵😁
Did your horn work before replacing the fuse?
Nope, but I sure enjoy the AC more than the horn 😄
Sheeit, my horn works but not the A/C
Did you have to disconnect the battery first or anything?
Nope, no need
My error code says bank 1, sensor 2. Which one is that?
👍🏻
Thanks, This video is too simple but VERY VERY VERY useful 👌. Can you put a link to order the lights?
I tried to go back to my order on Amazon but they are no longer available. I'd just order the brightest ones you can find.